1 January 2011 in Journal of Biological Chemistry
Processive cellobiohydrolases (CBHs) are the key components of fungal cellulase systems. Despite the wealth of structural data confirming the processive mode of action, little quantitative information on the processivity of CBHs is available. Here, we developed a method for measuring cellulase processivity. Sensitive fluorescence detection of enzyme-generated insoluble reducing groups on cellulose after labeling with diaminopyridine enabled quantification of the number of reducing-end exo-mode and endo-mode initiations. Both CBHs TrCel7A from Trichoderma reesei and PcCel7D from Phanerochaete chrysosporium employed reducing-end exo- and endo-mode initiation in parallel. Processivity values measured for TrCel7A and PcCel7D on cellulose hydrolysis were more than an order of magnitude lower than the values of intrinsic processivity that were found from the ratio of catalytic constant (k(cat)) and dissociation rate constant (k(off)). We propose that the length of the obstacle-free path available for a processive run on cellulose chain limits the processivity of CBHs on cellulose. TrCel7A and PcCel7D differed in their k(off) values, whereas the k(cat) values were similar. Furthermore, the k(off) values for endoglucanases (EGs) were much higher than the k(off) values for CBHs, whereas the k(cat) values for EGs and CBHs were within the same order of magnitude. These results suggest that the value of k(off) may be the primary target for the selection of cellulases.
24 March 2004 in Biotechnology and Bioengineering
1 August 2012 in Journal of Biological Chemistry
Synergistic cooperation of different enzymes is a prerequisite for efficient degradation of cellulose. The conventional mechanistic interpretation of the synergism between randomly acting endoglucanases (EGs) and chain end-specific processive cellobiohydrolases (CBHs) is that EG-generated new chain ends on cellulose surface serve as starting points for CBHs. Here we studied the hydrolysis of bacterial cellulose (BC) by CBH TrCel7A and EG TrCel5A from Trichoderma reesei under both single-turnover and “steady state” conditions. Unaccountable by conventional interpretation, the presence of EG increased the rate constant of TrCel7A-catalyzed hydrolysis of BC in steady state. At optimal enzyme/substrate ratios, the “steady state” rate of synergistic hydrolysis became limited by the velocity of processive movement of TrCel7A on BC. A processivity value of 66 ± 7 cellobiose units measured for TrCel7A on 14C-labeled BC was close to the leveling off degree of polymerization of BC, suggesting that TrCel7A cannot pass through the amorphous regions on BC and stalls. We propose a mechanism of endo-exo synergism whereby the degradation of amorphous regions by EG avoids the stalling of TrCel7A and leads to its accelerated recruitment. Hydrolysis of pretreated wheat straw suggested that this mechanism of synergism is operative also in the degradation of lignocellulose. Although both mechanisms of synergism are used in parallel, the contribution of conventional mechanism is significant only at high enzyme/substrate ratios.
1 January 2018 in Journal of Biological Chemistry
Lytic polysaccharide monooxygenases (LPMOs) catalyze the oxidative cleavage of glycosidic bonds in recalcitrant polysaccharides, such as cellulose and chitin, and are of interest in biotechnological utilization of these abundant biomaterials. It has recently been shown that LPMOs can use H2O2, instead of O2, as a co-substrate. This peroxygenase-like reaction by a mono-copper enzyme is unprecedented in nature and opens new avenues in chemistry and enzymology. Here, we provide the first detailed kinetic characterization of chitin degradation by the bacterial LPMO chitin-binding protein CBP21 using H2O2 as co-substrate. The use of [14C]-labeled chitin provided convenient and sensitive detection of the released soluble products, which enabled detailed kinetic measurements. The kcat for chitin oxidation found here (5.6 s-1) is more than an order of magnitude higher than previously reported (apparent) rate constants for reactions containing O2 but no added H2O2. The kcat/KM for H2O2-driven degradation of chitin was on the order of 106 M-1 s-1, indicating that LPMOs have catalytic efficiencies similar to those of peroxygenases. Of note, H2O2 also inactivated CBP21, but the second-order rate constant for inactivation was about three orders of magnitude lower than that for catalysis. In light of the observed CBP21 inactivation at higher H2O2 levels we conclude that controlled generation of H2O2, in situ, seems most optimal for fueling LPMO-catalyzed oxidation of polysaccharides.
1 January 2013 in Biotechnology for Biofuels
Enzyme end-product inhibition is a major challenge in the hydrolysis of lignocellulose at a high dry matter consistency. β-glucosidases (BGs) hydrolyze cellobiose into two molecules of glucose, thereby relieving the product inhibition of cellobiohydrolases (CBHs). However, BG inhibition by glucose will eventually lead to the accumulation of cellobiose and the inhibition of CBHs. Therefore, the kinetic properties of candidate BGs must meet the requirements determined by both the kinetic properties of CBHs and the set-up of the hydrolysis process.
29 June 2010 in Biotechnology and Bioengineering