Reinforcement bars of microcomposite (MC) steel, composed of lath martensite and minor amounts of retained austenite, possess improved strength and corrosion characteristics over low-carbon (LC) steel rebar; however, their performance under shear loading has not previously been investigated at the microstructural level. In this study, LC and MC steel cylinders were compression tested, and specimens machined into a forced-shear geometry were subjected to quasi-static and dynamic shear loading to determine their shear behavior as a function of the strain and strain rate. The as-received and sheared microstructures were examined using optical microscopy (OM), scanning electron microscopy (SEM), and electron backscatter diffraction (EBSD). Higher-resolution microstructural examinations were performed using transmission electron microscopy (TEM). The influence of the starting microstructure on the shear behavior was found to depend strongly on the strain rate; the MC steel exhibited not only greater strain-rate sensitivity than the LC steel but also a greater resistance to shear localization with load. In both steels, despite differences in the starting microstructure, post-mortem observations were consistent with a continuous mechanism operating within adiabatic shear bands (ASBs), in which subgrains rotated into highly misoriented grains containing a high density of dislocations.
Among A2BX4 compounds, those obtained with A as the tetraethylammonium group (C2H5)4N are tetragonal (in most of cases with P42/nmc — (D154k) in their high temperature phase. The copper compound presented here is particularly interesting: it transforms in a moist atmosphere to the hydrated compound (TEA)2CuCL4 O.S H2O of different structural organisation, and it exhibits two structural phase transitions: one, to an orthorhombic phase of symmetry (Pnna — D62h), is improper ferroelastic of an order-disorder type. The second occurs at lower temperature, is between phases of same symmetry and is isostructural-like. Moreover, the compound is a good candidate for the appearance of different glassy states.
1 March 2014 in Revista de la Academia Colombiana de Ciencias Exactas, Físicas y Naturales
In this work we evaluated the effect of the preparation method (auto-combustion vs impregnation), and of ruthenium as promoter (0.3 wt% Ru) for cobalt-based catalysts (10 wt% Co) supported on MgO-Al2O3 mixed oxides on the Fischer-Tropsch synthesis (FTS). Cobalt supported on MgO and Al2O3were used as reference catalysts for the mixed oxides. The activity of the catalysts for the FTS was evaluated in a fixed-bed reactor at 260°C and atmospheric pressure. According to the results and independently from the preparation method,cobalt supported on MgO-Al2O3 mixed oxides were more selective to heavy hydrocarbons (C5+) than catalysts supported on single (MgO or Al2O3) oxides. Furthermore, all Ru-promoted catalysts were more active (i.e., had higher conversion) than non-promoted catalysts, and the selectivity to hydrocarbon fractions in the range of gasoline (C5 – C11) and diesel (C12 – C21) increased. In general, the results suggest that Ru-promoted Co/MgO-Al2O3 catalyst is a promising catalytic system for the FTS.