17 June 2023 in Advanced Materials Technologies
A novel method for fabricating transparent porous γ‐alumina 3D structures by printing at high resolution is presented. The process is based on combining digital light processing 3D printing (DLP) and sol–gel reactions, all performed in transparent solutions, resulting in ceramic monolithic porous structures. The aqueous printing solution contains mainly aluminum chloride, propylene oxide (PO), ethanol, and acrylic acid (AA). The printed polymerized structures are aged, followed by supercritical drying (SCD), and sintered at high temperatures. During aging and sintering, the printed objects shrink, thus enabling a final printing resolution far beyond the nominal value of the used printer. The resulting structures are crystalline γ‐Al2O3, with a very high surface area, above 1800 m2 g−1, and optical transmission above 80% at 600 nm. In addition, SCD enables precise control of pores’ dimensions and total surface area, which are essential for applications including thermal insulation and catalyst support and for obtaining heat‐resistant transparent optical devices.
13 December 2024 in ACS Applied Materials & Interfaces
28 August 2024 in Additive Manufacturing
30 March 2026 in Journal of Sol-Gel Science and Technology
Transparent, rare-earth-doped silica-based glasses are promising candidates for photonic and laser applications due to their favorable optical properties. Here, we report the fabrication of three-dimensional silica-phosphate and silica-zirconia-phosphate (Nd³⁺-doped) glasses, using a sol-gel-derived, particle-free photocurable resin that is tailored for digital light processing (DLP) 3D printing and UV-assisted mold casting. The resin consists solely of sol-gel precursors and a dual photopolymerizable component, enabling high-resolution printing without particle dispersion. Following room-temperature aging and a short thermal treatment at 700 °C for 1 h, transparent, crack-free glasses were obtained. The resulting glass structures exhibited transmittance values of 76.2 ± 0.3% and 77.1 ± 0.2% at 680 nm and 850 nm, respectively, and retained an amorphous microstructure. Phosphate incorporation improved the distribution of Nd³⁺ ions and suppressed photoluminescence (PL) quenching, but partial phosphate loss occurred during sintering. The addition of zirconia effectively stabilizes the phosphate within the silica network, preserving the composition of the printing solution. Phosphate addition led to a pronounced enhancement of PL intensity, up to tenfold for the 92SiO₂-4P₂O₅-4ZrO₂ composition doped with 0.7 mol % Nd₂O₃, compared to phosphate-free glass (96SiO₂-4ZrO₂). This facile and combined photopolymerization and the sol-gel-based DLP printing process enable the fabrication of geometrically complex, compositionally tunable, transparent laser glasses, demonstrating a cost-effective route for developing custom photonic and optoelectronic components.
16 November 2026 in Israel Journal of Chemistry