Stormwater runoff contains a broad range of micropollutants. In Europe a number of these substances are regulated through the Water Framework Directive, which establishes Environmental Quality Standards (EQSs) for surface waters. Knowledge about discharge of these substances through stormwater runoff and combined sewer overflows (CSOs) is essential to ensure compliance with the EQSs. Results from a screening campaign including more than 50 substances at four stormwater discharge locations and one CSO in Copenhagen are reported here. Heavy metal concentrations were detected at levels similar to earlier findings, e.g., with copper found at concentrations up to 13 times greater than the Danish standard for surface waters. The concentration of polyaromatic hydrocarbons (PAHs) exceeded the EQSs by factors up to 500 times for stormwater and 2,000 times for the CSO. Glyphosate was found in all samples whilst diuron, isoproturon, terbutylazine and MCPA were found only in some of the samples. Diethylhexylphthalate (DEHP) was also found at all five locations in concentrations exceeding the EQS. The results give a valuable background for designing further monitoring programmes focusing on the chemical status of surface waters in urban areas.
Polyethylene (PE) and cross-linked polyethylene (PEX) pipes are frequently used in water supply systems. Such pipes contain added antioxidants with phenolic structures, e.g. Irgafos 168, Irganox 1010 and 1076, in order to improve durability. However, phenol, ketone and quinone antioxidant degradation products may leach and enter drinking water. The aim of this investigation was to develop a method for measuring these degradation products with a performance meeting the drinking water quality criteria of 20 µg L−1. Using headspace solid phase microextraction coupled to a gas chromatograph with a mass spectrometer, a method was established revealing limits of detection and quantification less than 0.4 and 1 µg L−1 respectively. The method was applied to migration experiments for two PEX pipes and one PE material, quantifying the release of two degradation products. Highest concentrations were observed for 2,6-di-tert-butyl-p-benzoquinone which in one of the two pipes was found in concentrations of 18–57 µg L−1 in each of eight consecutive release experiments.