1 August 2018 in Journal of the Mechanical Behavior of Biomedical Materials
11 July 2022 in Advanced Science
Photodetectors that are intimately interfaced with human skin and measure real‐time optical irradiance are appealing in the medical profiling of photosensitive diseases. Developing compliant devices for this purpose requires the fabrication of photodetectors with ultraviolet (UV)‐enhanced broadband photoresponse and high mechanical flexibility, to ensure precise irradiance measurements across the spectral band critical to dermatological health when directly applied onto curved skin surfaces. Here, a fully 3D printed flexible UV‐visible photodetector array is reported that incorporates a hybrid organic‐inorganic material system and is integrated with a custom‐built portable console to continuously monitor broadband irradiance in‐situ. The active materials are formulated by doping polymeric photoactive materials with zinc oxide nanoparticles in order to improve the UV photoresponse and trigger a photomultiplication (PM) effect. The ability of a stand‐alone skin‐interfaced light intensity monitoring system to detect natural irradiance within the wavelength range of 310–650 nm for nearly 24 h is demonstrated.
1 August 2019 in Journal of the Mechanical Behavior of Biomedical Materials
23 May 2018 in Royal Society Open Science
Possible links between adhesive properties and the pre-sliding (static) friction response of cartilage are not fully understood in the literature. The aims of this study are to investigate the relation between adhesion and relaxation time in articular cartilage, and the effect of relaxation-dependent adhesion on the pre-sliding response of cartilage. Adhesion tests were performed to evaluate the work of adhesion of cartilage at different relaxation times. Friction tests were conducted to identify the pre-sliding friction response of cartilage at relaxation times corresponding to adhesion tests. The pre-sliding friction response of cartilage was systematically linked to the work of adhesion and contact conditions by a slip-based failure model. It was found that the work of adhesion increases with relaxation time. Also, the work of adhesion is linearly correlated to the resistance to slip-based failure. In addition, as the work of adhesion increases, the adhered (stick) area at the moment of failure increases, and the propagation rate of the annular slip (crack) area towards its centre increases. These findings offer a mechanistic explanation of the pre-sliding friction behaviour and stick–slip response of soft hydrated interfaces such as articular cartilage and hydrogels. In addition, the linear correlation between adhesion and threshold to slip-based failure enables estimation of the adhesive strength of such interfaces directly from the pre-sliding friction response (e.g. shear wave elastography).
23 July 2025 in Advanced Healthcare Materials
The transplantation of regionally specific spinal neural progenitor cells (sNPCs) has shown promise for functional restoration after spinal cord injury (SCI) by forming connections with host neural circuits. Here, 3D‐printed organoid scaffolds for transplantation using clinically relevant human induced pluripotent stem cell‐derived regionally specific sNPCs is developed. Scaffolds with microscale channels are printed, and sNPCs are subsequently printed within these channels. The scaffolds direct axonal projections along the channels and guide the cells to simulate in vivo‐like conditions, leading to more effective cell maturation and the development of neuronal networks crucial for restoring function after SCI. The scaffolds, with organoids assembled along their lengths, are transplanted into the transected spinal cords of rats. This significantly promotes the functional recovery of the rats. At 12 weeks post‐transplantation, the majority of the cells in the scaffolds differentiate into neurons and integrate into the host spinal cord tissue. These results demonstrate their potential to create a relay system along the spinal cord and form synapses in both the rostral and caudal directions relative to the scaffold. It is envisioned that combining sNPCs, organoid assembly, and 3D printing strategies can ultimately lead to a transformative treatment approach for SCI.
1 October 2020 in Journal of the Mechanical Behavior of Biomedical Materials