The mucilage that accumulated in the Sea of Marmara in 2021 turned into an environmental disaster that threatened not only marine life but also the shipping and tourism industries. However, because of the partially organic structure of marine mucilage, it has the potential to be used as an additive for polymer films. In this study, bioplastic films were prepared from PVA with a series of mucilage content from 0% to 50% by mass, and their properties were investigated. The FT‐IR spectra revealed a shift in hydroxyl peaks, suggesting an interaction between the mucilage and PVA. SEM images showed the formation of crystal forms at the higher mucilage content of 20%, indicating ionic saturation of the PVA matrix. EDX and XRD analyses revealed that the crystal was NaCl coming from the mucilage composition. The tensile strength of the neat PVA film was measured as 9.86 MPa and improved to 14.56 MPa with 5% mucilage content, which is attributed to the ionic cross‐linking. The tensile properties were preserved up to 20% of the mucilage content, and then sudden decrements were observed. The transmittance percentage ( T %) of the neat PVA film in UV–Vis spectra (800–200 nm) was detected as 75% at 500 nm and decreased down to 39% with increased mucilage content up to 50%. Furthermore, a rising limit of linearity (LOL) of the spectrums was observed from 350 to 580 nm, with increasing mucilage content from 5% to 50%. The biofilms showed antibacterial activity against Escherichia coli and Staphylococcus aureus bacteria. Hence, a robust and biodegradable film having UV protection and antibacterial activity was developed from the marine mucilage bio‐waste. Highlights: Poly(vinyl alcohol)/marine mucilage biocomposite films were prepared. Biocomposite films showed increased UV‐A, UV‐B, and UV‐C protection with increased mucilage content. Enhanced tensile strength of biocomposite films up to 20 wt% mucilage content was determined due to ionic crosslink formed by NaCl salt ions. Biocomposite exhibited antibacterial activity against Escherichia coli and Staphylococcus aureus .
Among biobased and biodegradable polymers, polylactic acid (PLA) is most widely used one. However, its poor mechanical properties need to be enhanced. In this study, PLA blend film with improved mechanical properties were developed without compromising any bio-content. For this, natural rubber derivative with acetate pendant group (ANR) and PLA blend films were prepared. First, natural rubber was epoxidized, and then partial acetylation was achieved by the ring-opening reaction of the epoxy groups. The epoxidation and the acetylation were examined by FTIR analysis. 1H-NMR spectrum revealed a 29% epoxidation and 8.25% acetylation degree. The Tg of natural rubber (−66°C) increased to −41°C and −31°C after epoxidation and acetylation, respectively. The compatibility of ENR and ANR with PLA was evident from the DSC results and Molau test. The morphology of PLA blend film containing 25 wt% of ANR (ANR25) was observed as well-dispersed fine droplets by SEM images. The tensile strength, elastic modulus, and yield strength of ANR25 were measured as 11.6 MPa, 397.3 MPa, and 6.9 MPa, respectively. These values are considerably higher than neat PLA film. Compared to reported studies on PLA toughening so far, increments in both the strength and elongation of ANR25 were observed by tensile tests. Moreover, highest toughness among all samples was determined as 18.8 MJm−3 for ANR25, which is 1.8 times higher than neat PLA. Thus, a strong and tough bio-based PLA blend was developed for film application such as packaging and sheeting.
7 December 2019 in International Journal of Minerals, Metallurgy and Materials