10 January 2019 in Journal of Solid State Electrochemistry
A review presents applications of different forms of elemental carbon in lead-acid batteries. Carbon materials are widely used as an additive to the negative active mass, as they improve the cycle life and charge acceptance of batteries, especially in high-rate partial state of charge (HRPSoC) conditions, which are relevant to hybrid and electric vehicles. Carbon nanostructures and composite materials can also play such a role. The positive active mass additions are generally less beneficial than the negative ones. Carbon can also be applied as a material for reticulated current collectors for both negative and positive plates. This modern technology allows to increase the battery specific energy and active mass utilization. Batteries with such collectors can show improved cycle life, owing to a better active mass mechanical support. Other recent use of carbon in secondary batteries is as supercapacitor electrodes. They can replace the negative plate or be connected in parallel with such a lead plate. These solutions increase the specific power and HRPSoC performance. Presented new carbon-based technologies in a construction of lead-acid batteries can significantly improve their performance and allow a further successful competition with other battery systems.
9 May 2018 in Journal of Solid State Electrochemistry
Reticulated vitreous carbon (RVC) plated electrochemically with a thin layer of lead was investigated as a carrier and current collector material for the positive and negative plates for lead-acid batteries. Flooded 2 V single lead-acid cells, with capacities up to 46 Ah, containing two positive and two negative plates were assembled and subjected to charge/discharge cycling tests, self-discharge characterization and Peukert’s dependences determination. They could retain 72% of discharge capacity after 12 months of storage in room temperature and showed similar performance to a standard cell during cycle life test. A 2-V cell using a carbon material with higher conductivity than RVC was also constructed. It showed improved performance under higher current discharges, comparable to standard lead-acid batteries. Additional cycling tests were performed on a complete 12-V RVC-based battery. It completed almost three times the number of cycles of lead-acid batteries with standard current collectors. Obtained results are promising and show that application of a conducting porous carbon as a carrier and current-collector will significantly increase the specific capacity of the lead-acid battery and self-discharge characterization and cycling charging–discharging battery durability.
1 April 2015 in Journal of Electroanalytical Chemistry
16 August 2022 in International Journal of Environmental Science and Technology
The objective of the presented study was the recovery of Zn, Cr, Cu and Co in the form of powders and nanopowders from various types of industrial wastewaters. Powders and nanopowders as products of high added value find a wide applications in nanotechnology and material science and engineering. The metallic powders were obtained using potentiostatic electroreduction (potential-controlled electrolysis). The chosen method offers better control of the purity and structure of the products. The structure and size of crystallites depend on the value of electrolysis potentials and time, cathode material, concentrations of metal ions. In this investigation, the powders of different sizes ranging from 90 to 230 nm for Cr, 100–4000 nm for Zn, 25–100 nm for Co and 40–660 nm for Cu were deposited. The compositions, purity and size of the cathode deposits were confirmed by scanning electron microscopy and energy-dispersive X-ray spectroscopy. Presented metal recovery method is a promising technique for industrial application, given its simplicity, economic viability and environmental sustainability. It can be used on a wide range of solutions and help in reducing the problem of the growing amounts of industrial wastewater.