9 June 2009 in Journal of Materials Science
16 March 2009 in Applied Physics Letters
ceramics have been investigated using x-ray diffraction (XRD) and electron diffraction (ED). XRD patterns for were consistent with rhombohedral , whereas those for and exhibited peak splitting and superlattice reflections representative of orthorhombic, antiferroelectric . ED for the latter samples confirmed the presence of superlattice reflections typical of a -like structure but additional superlattice reflections were observed at yielding a (where is the pseudocubic lattice parameter) unit cell. The transition from rhombohedral to the -like structure implies a modification from polar to antipolar behavior.
5 August 2011 in Advanced Functional Materials
5 December 2005 in Applied Physics Letters
Perovskite-structured ceramics in the (BSF-PT) system were fabricated for in which a morphotropic phase boundary (MPB) occurred between rhombohedral and tetragonal phases at . Samples close to the MPB gave piezoelectric and electromechanical coupling coefficients of and 0.5, respectively. The low cost of BSF-PT in comparison to (BS-PT) coupled with its high and usable piezoelectric properties suggests future commercial exploitation.
1 August 2013 in APL Materials
Observation of an unusual, negatively-charged antiphase boundary in (Bi0.85Nd0.15)(Ti0.1Fe0.9)O3 is reported. Aberration corrected scanning transmission electron microscopy is used to establish the full three dimensional structure of this boundary including O-ion positions to ∼±10 pm. The charged antiphase boundary stabilises tetragonally distorted regions with a strong polar ordering to either side of the boundary, with a characteristic length scale determined by the excess charge trapped at the boundary. Far away from the boundary the crystal relaxes into the well-known Nd-stabilised antiferroelectric phase.
15 October 2009 in Journal of Applied Physics
Ceramics around the morphotropic phase boundary (MPB) in the solid solution were fabricated. For , ceramics were single phase, and piezoelectric coefficients and electromechanical coupling coefficients for MPB compositions were 300 pC/N and 0.49, respectively; a level of piezoelectric activity similar to that of hard, lead zirconate titanate compositions but with higher at . For ceramics with , dielectric measurements in combination with diffraction contrast transmission electron microscopy revealed the existence of two ferroelectric phases for most contents studied. The presence of two ferroelectric phases was associated with a decrease in piezoelectric activity and although raw materials costs for and 0.8 with respect to were significantly lower (less ) and greater , and (0.18) were too low to be commercially useful for actuator applications.