11 November 2019 in Water Resources Research
In semidistributed hydrological modeling, sequential calibration usually refers to the calibration of a model by considering not only the flows observed at the outlet of a catchment but also the different gauging points inside the catchment from upstream to downstream. While sequential calibration aims to optimize the performance at these interior gauged points, we show that it generally fails to improve performance at ungauged points. In this paper, we propose a regularization approach for the sequential calibration of semidistributed hydrological models. It consists in adding a priori information on optimal parameter sets for each modeling unit of the semidistributed model. Calibration iterations are then performed by jointly maximizing simulation performance and minimizing drifts from the a priori parameter sets. The combination of these two sources of information is handled by a parameter k to which the method is quite sensitive. The method is applied to 1,305 catchments in France over 30 years. The leave‐one‐out validation shows that, at locations considered as ungauged, model simulations are significantly improved (over all the catchments, the median KGE criterion is increased from 0.75 to 0.83 and the first quartile from 0.35 to 0.66), while model performance at gauged points is not significantly impacted by the use of the regularization approach. Small catchments benefit most from this calibration strategy. These performances are, however, very similar to the performances obtained with a lumped model based on similar conceptualization.
24 May 2022 in Hydrology and Earth System Sciences
A climatic anomaly can potentially affect the hydrological behaviour of a catchment for several years. This article presents a new approach to quantifying this multi-year hydrological memory, using exclusively streamflow and climate data. Rather than providing a single value of catchment memory, we aim to describe how this memory fades over time. The precipitation–runoff relationship is analyzed through the concept of elasticity. Elasticity quantifies the change in one quantity caused by the change in another quantity. We analyze the elasticity of the relation between the annual anomalies of runoff yield and humidity index. We identify Catchment Forgetting Curves (CFC) to quantify multi-year catchment memory, considering not only the current year's humidity anomaly but also the anomalies of the preceding years. The variability of CFCs is investigated on a set of 158 Swedish and 527 French catchments. As expected, French catchments overlying large aquifers exhibit a long memory, i.e., with the impact of climate anomalies detected over several years. In Sweden, the expected effect of the lakes is less clear. For both countries, a relatively strong relationship between the humidity index and memory is identified, with drier regions exhibiting longer memory. Taking into account the multi-year memory has significantly improved the elasticity analysis for 15 % of the catchments. Our work thus underlines the need to account for catchment memory in order to produce meaningful and geographically coherent elasticity indices.
12 May 2016 in Proceedings of IAHS
Ideally, semi-distributed hydrologic models should provide better streamflow simulations than lumped models, along with spatially-relevant water resources management solutions. However, the spatial distribution of model parameters raises issues related to the calibration strategy and to the identifiability of the parameters. To analyse these issues, we propose to base the evaluation of a semi-distributed model not only on its performance at streamflow gauging stations, but also on the spatial and temporal pattern of the optimised value of its parameters. We implemented calibration over 21 rolling periods and 64 catchments, and we analysed how well each parameter is identified in time and space. Performance and parameter identifiability are analysed comparatively to the calibration of the lumped version of the same model. We show that the semi-distributed model faces more difficulties to identify stable optimal parameter sets. The main difficulty lies in the identification of the parameters responsible for the closure of the water balance (i.e. for the particular model investigated, the intercatchment groundwater flow parameter).
22 September 2023 in Hydrology and Earth System Sciences
Large datasets of long-term streamflow measurements are widely used to infer and model hydrological processes. However, streamflow measurements may suffer from what users can consider anomalies, i.e. non-natural records that may be erroneous streamflow values or anthropogenic influences that can lead to misinterpretation of actual hydrological processes. Since identifying anomalies is time consuming for humans, no study has investigated their proportion, temporal distribution, and influence on hydrological indicators over large datasets. This study summarizes the results of a large visual inspection campaign of 674 streamflow time series in France made by 43 evaluators, who were asked to identify anomalies falling under five categories, namely, linear interpolation, drops, noise, point anomalies, and other. We examined the evaluators' individual behaviour in terms of severity and agreement with other evaluators, as well as the temporal distributions of the anomalies and their influence on commonly used hydrological indicators. We found that inter-evaluator agreement was surprisingly low, with an average of 12 % of overlapping periods reported as anomalies. These anomalies were mostly identified as linear interpolation and noise, and they were more frequently reported during the low-flow periods in summer. The impact of cleaning data from the identified anomaly values was higher on low-flow indicators than on high-flow indicators, with change rates lower than 5 % most of the time. We conclude that the identification of anomalies in streamflow time series is highly dependent on the aims and skills of each evaluator, which raises questions about the best practices to adopt for data cleaning.
5 February 2025 in Hydrology and Earth System Sciences
The transferability of hydrological models over contrasting climate conditions, also identified as model robustness, has been the subject of much research in recent decades. The occasional lack of robustness identified in such models is not only an operational challenge – since it affects the confidence that can be placed in projections of climate change impact – it also hints at possible deficiencies in the structures of these models. This paper presents a large-scale application of the robustness assessment test (RAT) for three hydrological models with different levels of complexity: GR6J, HYPE and MIKE SHE. The dataset comprises 352 catchments located in Denmark, France and Sweden. Our aim is to evaluate how robustness varies over the dataset and between models and whether the lack of robustness can be linked to some hydrological and/or climate characteristics of the catchments (thus providing a clue as to where to focus model improvement efforts). We show that, although the tested models are very different, they encounter similar robustness issues over the dataset. However, models do not necessarily lack robustness in the same catchments and are not sensitive to the same hydrological characteristics. This work highlights the applicability of the RAT regardless of model type and its ability to provide a detailed diagnostic evaluation of model robustness issues.
17 June 2016 in Water Resources Research
Few methods directly transfer streamflow measurements for continuous prediction of ungauged catchments. Top‐kriging has been used mainly to predict the statistical properties of runoff but has been shown to outperform traditional regionalization approaches of rainfall‐runoff models. We applied the Top‐kriging approach across the Loire River basin and compared predictions to a geomorphology‐based approach. Whereas Top‐kriging uses spatial correlation, the other approach has the advantage of being more physically based by using a well‐known geomorphology‐based hydrological model (WFIUH) and its inversion. Both approaches require an equal degree of calibration and provide similar performances. We also demonstrate that the Ghosh distance, which considers the nested nature of catchments, can be used efficiently to calculate weights and to identify the suitability of gauged catchments for use as donor catchments. This result is particularly relevant for catchments with Strahler orders above five, i.e., where donor catchments are more strongly nested.