1 February 1995 in Physics Letters B
The production of B∗ mesons in Z decays has been measured at LEP with the L3 detector. A sample of Z → bb events was obtained by tagging muons in 1.6 million hadronic Z decays collected in 1991, 1992 and 1993. A signal with a peak value of Eγ = 46.3 ± 1.9 (stat) MeV in the B rest fram
10 October 2008 in IEEE Journal on Selected Areas in Communications
This work explores the performance of a multiple-input multiple-output broadcast channel where both the transmitter and receivers have outdated channel knowledge due to node motion or other time-variations in the communication channel. A performance analysis based on measured channel responses reveals significant throughput degradation for optimal linear and nonlinear precoding strategies unless the channel state information (CSI) is frequently fed back to the transmitter. The paper then develops a linear beamforming precoding strategy based on channel distribution information in the form of a full spatial correlation matrix for each user. This algorithm is shown to provide highly stable communication, with a throughput that is higher than that for optimal precoders operating on outdated CSI, in a time-variant environment, indicating that this approach can operate with significantly reduced feedback frequency. Furthermore, the paper demonstrates the use of the well-known Kronecker and Weichselberger models to parameterize the full correlation matrix to enable further reduction in the amount of feedback data required for implementation of the new beamforming technique.
6 April 2018 in IEEE Transactions on Vehicular Technology
Spectrum sensing in next-generation wireless radio networks is considered a key technology to overcome the problem of spectrum scarcity. Unfortunately, many approaches to spectrum sensing do not work well in low signal-to-noise ratio (SNR) environments. This paper proposes and analyzes a new algorithm named kernelized generalized likelihood ratio test (KGLRT) for spectrum sensing in cognitive radio systems to overcome this problem. Effectively, KGLRT uses a nonlinear kernel to map input data onto a high-dimensional feature space; then, the widely accepted (linear) generalized likelihood ratio test is used for hypothesis testing. This new algorithm gives a gain of 4 dB in SNR over its linear counterpart. A theoretical analysis for this algorithm is given for the first time and is shown analogous to algorithms used in image signal processing. The detection metrics are found to be concentrated random variables; furthermore, the probability distributions of the detection metrics are proved to follow the F -distributions, which agree with the results obtained using the concentration inequality. The analytical thresholds are derived for target false-alarm probabilities. The thresholds are independent of noise power; thus, the proposed algorithm can overcome noise uncertainty issues at very low SNR levels. Simulations validate the theoretical results.
6 January 2012 in IEEE Journal of Selected Topics in Signal Processing
In a distributed antenna multiple-input multiple- output (MIMO) multiuser channel, multiple nodes simultaneously access the wireless channel by cooperating to achieve virtual MIMO links, enabling improved exploitation of the channel spatial dimensions. However, practical considerations dictate that in such a system, the transmit power from each cooperating node must be constrained in a per-antenna power constraint, which differs from the sum-power constraint typical of multiuser MIMO signaling. Furthermore, existing multiuser MIMO communication algorithms are appropriate for specific assumptions regarding the signaling strategy allowed. This paper provides a general framework able to accommodate a variety of multiuser MIMO channel topologies, precoding techniques (linear or nonlinear), and power constraints including the per-antenna constraint appropriate for the cooperative MIMO channel involving heterogeneous nodes. In contrast to prior work incorporating per-antenna power constraints, the algorithm enables reduced implementation and computational complexity by avoiding the requirement of numerical optimization. Simulation results using both modeled and measured cooperative channel responses demonstrate that the sum rate of a cooperative broadcast channel with a per-antenna power constraint is very close to the optimal bound achieved using a sum-power constraint, even in practical scenarios. Additional results demonstrate the straightforward application of the algorithm to different practical multiuser topologies.
7 December 2018 in IEEE Transactions on Smart Grid
Unintended radiated emissions (URE) from electronic devices are conducted on to the power infrastructure and can be collected and analyzed for non-intrusive load monitoring (NILM) applications. Dimensionally aligned signal projections (DASP) were previously introduced as specialized signal transforms to enable device classification using machine learning on statistical features derived from the DASP transforms. In this work, we explore multi-device classification which requires more sophisticated methods owing to the complexity of the feature space such as large dynamic range, non-contiguous features, over-lapping features, and nonlinear interactions of features. In particular, we introduce an additional DASP algorithm for increased resolution and sensitivity to intermodulation products and examine the utility of convolutional neural networks (CNNs) to extract and learn features directly from DASP images for classification of single and multiple device URE captures.
18 June 2015 in IEEE Transactions on Antennas and Propagation
FSFarnaz Karimdady Sharifabad
Farnaz Karimdady Sharifabad
While transmit and receive beamforming for the multiple-input multiple-output (MIMO) point-to-point channel is a well-studied topic, existing algorithms cannot specify effective beamformers for certain situations. To address this deficiency, we present an iterative algorithm that can establish beamformers based on different channel information available to the transmitter and receiver, different receiver architectures, and different constraints on the power radiated by the transmit array. Simulation results based on modeled and measured channels demonstrate that the algorithm effectively accommodates a wide range of conditions and that the performance achieved with the approach matches that obtained using existing algorithms that are applicable only to specific conditions.