We combine aftershock relocations, source mechanisms, teleseismicPwave backprojection, and Global Positioning System data inversion to constrain complex faulting geometry of the 2018 MW7.9 offshore Kodiak earthquake. Relocated aftershocks delineate several N‐S trends including a prominent 110‐km‐long segment, as well as broad NE‐SW trends. Global Positioning System modeling and backprojection indicate that the NE‐SW trending left‐lateral strike‐slip segments released most energy dominating far‐field crustal deformation and radiated wavefield. Backprojection infers fast E‐to‐W rupture propagations superimposed on a slower S‐to‐N migration. We propose a five‐segment model of the rupture that was partially driven by dynamic triggering.
The 7.1 47 km deep earthquake that occurred on 30 November 2018 had deep societal impacts across southcentral Alaska exhibited phenomena of broad scientific interest. We document observations that point to future directions of research and hazard mitigation. The rupture mechanism, aftershocks, and deformation of the mainshock are consistent with extension inside the Pacific plate near the down‐dip limit of flat‐slab subduction. Peak ground motions were observed across more than , though the most violent near‐fault shaking was avoided because the hypocenter was nearly 50 km below the surface. The ground motions show substantial variation, highlighting the influence of regional geology and near‐surface soil conditions. Aftershock activity was vigorous with roughly 300 felt events in the first six months, including two dozen aftershocks exceeding M 4.5. Broad subsidence of up to 5 cm across the region is consistent with the rupture mechanism. The passage of seismic waves and possibly the coseismic subsidence mobilized ground waters, resulting in temporary increases in stream flow. Although there were many failures of natural slopes and soils, the shaking was insufficient to reactivate many of the failures observed during the 1964 M 9.2 earthquake. This is explained by the much shorter duration of shaking as well as the lower amplitude long‐period motions in 2018. The majority of observed soil failures were in anthropogenically placed fill soils. Structural damage is attributed to both the failure of these emplaced soils as well as to the ground motion, which shows some spatial correlation to damage. However, the paucity of instrumental ground‐motion recordings outside of downtown Anchorage makes these comparisons challenging. The earthquake demonstrated the challenge of issuing tsunami warnings in complex coastal geographies and highlights the need for a targeted tsunami hazard evaluation of the region. The event also demonstrates the challenge of estimating the probabilistic hazard posed by intraslab earthquakes.
The 30 November 2018 magnitude 7.1 Anchorage earthquake occurred as a result of normal faulting within the lithosphere of subducted Yakutat slab. It was followed by a vigorous aftershock sequence with over 10,000 aftershocks reported through the end of July 2019. The Alaska Earthquake Center produced a reviewed aftershock catalog with a magnitude of completeness of 1.3. This well‐recorded dataset provides a rare opportunity to study the relationship between the aftershocks and fault rupture of a major intraslab event. We use tomoDD algorithm to relocate 2038 aftershocks with a regional 3D velocity model. The relocated aftershocks extend over a 20 km long zone between 47 and 57 km depth and are primarily confined to a high region. Aftershocks form two clusters, a diffuse southern cluster and a steeply west‐dipping northern cluster with a gap in between where maximum slip has been inferred. We compute moment tensors for the aftershocks using a cut‐and‐paste method and careful selection of regional broadband stations. The moment tensor solutions do not exhibit significant variability or systematic differences between the northern and southern clusters and, on average, agree well with the mainshock fault‐plane parameters. We propose that the mainshock rupture initiated in the Yakutat lower crust or uppermost mantle and propagated both upward into the crust to near its top and downward into the mantle. The majority of the aftershocks are confined to the seismically active Yakutat crust and located both on and in the hanging wall of the mainshock fault rupture.
Seismic network coverage in Alaska has fundamentally changed with the presence of the USArray Transportable Array (TA) stations. These new stations provided an unprecedented opportunity to expand earthquake reporting in areas of Alaska that have not previously been instrumented. The Alaska Earthquake Center (AEC) has been incorporating all TA data into its standard earthquake analysis. The TA network is currently the second largest contributor of phase picks in the Alaska earthquake catalog, after the AK network operated by the AEC. Recent increases in reported earthquakes (about 45,000 in 2017 and 55,000 in 2018) are directly attributable to the additional TA stations, especially in the northern and western mainland Alaska. In some regions, the earthquake detection threshold decreased by as much as two units of magnitude. With the TA installation complete in 2017, the detection threshold over the entire mainland Alaska region is . The new stations have also led to a decrease in hypocentral location errors, which are now more uniform over the entire mainland Alaska region. The uniformity of the TA network made it possible, for the first time, to make quantitatively valid comparisons of microseismic activity in different parts of the state. Among other observations, this uniform coverage helped demonstrate that the quiescence that has long been inferred in the central and western Arctic Slope region appears to be real, and not just an artifact of network coverage. This combined network should, with time, provide vastly better data for seismic hazard assessments in an area of increasing national interest.
29 November 2022 in Seismological Research Letters
The Alaska Amphibious Community Seismic Experiment (AACSE) comprised 75 ocean‐bottom seismometers and 30 land stations and covered about 650 km along the segment of the subduction zone that includes Kodiak Island, the Alaska Peninsula and the Shumagin Islands between May 2018 and September 2019. This unprecedented onshore‐offshore dataset provided an opportunity to compile a greatly enhanced earthquake catalog for the region by both increasing the number of detected earthquakes and improving the accuracy of their source parameters. We use all available regional and AACSE campaign seismic data to compile an earthquake catalog for the region between Kodiak and the Shumagin Islands including the Alaska Peninsula (51° N–59° N, 148° W–163° W). We apply the same processing and reporting standards to additional picks and events as the Alaska Earthquake Center currently uses for compilation of the authoritative regional earthquake catalog. Over 7200 events (both newly detected and previously reported) have been processed with AACSE data. We added about 30% more events, 60% more phase picks, lowered the magnitude of completeness by about 0.2 on average across the region, and improved location errors. All data have been published in public data archives. In addition, we test the machine‐learning earthquake detection and picking algorithm EarthquakeTransformer (EQT) on the AACSE seismic dataset, comparing EQT‐determined P and S picks with the new catalog. EQT is entirely trained on land data, whereas AACSE is amphibious. Overall, EQT finds 59% of P and 63% of S arrivals in the catalog within 300 km epicentral distance. The percent of catalog picks detected by EQT varies inversely with earthquake epicentral distance, and EQT performs particularly poorly on data from earthquakes recorded by instruments in the outer rise.