Interferometric synthetic aperture radar (InSAR) decorrelation that creates great challenges to phase unwrapping has been a critical issue for mapping large earthquake deformation. Some studies have proposed a “remove-and-return model” solution to tackle this problem, but it has not been fully validated yet, and therefore has rarely been applied to real earthquake scenarios. In this study, we use the 2023 Mw 7.8 and 7.6 earthquake doublet in Turkey and Syria as a case example to develop an iterative modeling method for InSAR-based coseismic mapping. We first derive surface deformation fields using Sentinel-1 offset tracking and Sentinel-2 optical image correlation, and invert them for an initial coseismic slip model, based on which we simulate InSAR coseismic phase measurements. We then remove the simulated phase from the actual Sentinel-1 phase and conduct unwrapping. The simulated phase is added back to the unwrapped phase to produce the final phase measurements. Comparing to the commonly-used unwrapping method, our proposed approach can significantly improve coherence and reduce phase gradients, enabling accurate InSAR measurements. Combining InSAR, offset tracking and optical image correlation, we implement a joint inversion to obtain an optimal coseismic slip model. Our model shows that slip on the Çardak Fault is concentrated on a ∼100 km segment; to both ends, slip suddenly diminished. On the contrary, rupture on the East Anatolian Fault Zone propagated much longer as its geometry is fairly smooth. The iterative coseismic modeling method is proven efficient and can be easily applied to other continental earthquakes.
The 2025 destructive Myanmar earthquake ruptured the previously recognized seismic gap along the Sagaing fault, with the longest ever recorded surface ruptures (500 km). Here, we use SAR and optical images to characterize coseismic and early postseismic deformation of this event. North‐south displacements delineate the extent of surface ruptures, which are confined between historically ruptured regions, supported by dramatic slip reductions along the strike near the two rupture terminations. Coseismic slip model suggests two high‐slip zones of distinct sizes separated by a low‐slip zone. Coseismic slip has peak values at the surface almost all along the rupture, suggesting an absence of shallow slip deficits. Early postseismic deformation over 1 month after the event is obtained by optical horizontal offsets. Rapid shallow afterslip (5 cm/day) is only found along the southern segment, with some spatial overlap with coseismically slipped zones indicating frictional heterogeneity of the Sagaing fault.
Quantifying fault frictional properties is fundamental to understanding slip behavior and seismic hazard. We analyze 2 years of Sentinel‐1 SAR data following the 2023 Turkey earthquake doublet using Independent Component Analysis‐enhanced Small Baseline Subset‐InSAR, to resolve postseismic deformation and invert for afterslip on the East Anatolian and Çardak faults. Within a rate‐and‐state framework, we estimate the friction parameter in postseismically stable regions ( R2 > 0.9), showing that afterslip dominantly occurs in high velocity‐strengthening regions, whereas coseismic rupture and aftershocks cluster near low zones or adjacent unstable patches. Depth‐dependent slip partitioning indicates a brittle–ductile transition modulated by frictional heterogeneity, and eastward migration of deep afterslip and segmentation of slip behavior highlight postseismic deformation complexity. Elevated values on the Pütürge segment indicate rupture propagation was limited by velocity‐strengthening regions. These results suggest that frictional heterogeneity likely governs slip partitioning and provide quantitative constraints for seismic hazard assessment in continental fault systems.