1 November 2011 in Seismological Research Letters
During the period between September 2010 and June 2011, the city of Christchurch was strongly shaken by a series of earthquakes that included the 4 September 2010 (Mw = 7.1), 26 December 2010 (Mw = 4.8), 22 February 2011 (Mw = 6.2), and 13 June 2011 (Mw = 5.3 and Mw = 6.0) earthquakes. The moment magnitude (Mw) values adopted in this paper are taken from GNS Science, New Zealand (http://www.geonet.org.nz); they are 0.1 units higher than the corresponding Mw values reported by the U.S....
31 December 2011 in Bulletin of the New Zealand Society for Earthquake Engineering
The 22 February 2011, Mw6.2-6.3 Christchurch earthquake is the most costly earthquake to affect New Zealand, causing 181 fatalities and severely damaging thousands of residential and commercial buildings, and most of the city lifelines and infrastructure. This manuscript presents an overview of observed geotechnical aspects of this earthquake as well as some of the completed and on-going research investigations. A unique aspect, which is particularly emphasized, is the severity and spatial extent of liquefaction occurring in native soils. Overall, both the spatial extent and severity of liquefaction in the city was greater than in the preceding 4th September 2010 Darfield earthquake, including numerous areas that liquefied in both events. Liquefaction and lateral spreading, variable over both large and short spatial scales, affected commercial structures in the Central Business District (CBD) in a variety of ways including: total and differential settlements and tilting; punching settlements of structures with shallow foundations; differential movements of components of complex structures; and interaction of adjacent structures via common foundation soils. Liquefaction was most severe in residential areas located to the east of the CBD as a result of stronger ground shaking due to the proximity to the causative fault, a high water table approximately 1m from the surface, and soils with composition and states of high susceptibility and potential for liquefaction. Total and differential settlements, and lateral movements, due to liquefaction and lateral spreading is estimated to have severely compromised 15,000 residential structures, the majority of which otherwise sustained only minor to moderate damage directly due to inertial loading from ground shaking. Liquefaction also had a profound effect on lifelines and other infrastructure, particularly bridge structures, and underground services. Minor damage was also observed at flood stop banks to the north of the city, which were more severely impacted in the 4th September 2010 Darfield earthquake. Due to the large high-frequency ground motion in the Port hills numerous rock falls and landslides also occurred, resulting in several fatalities and rendering some residential areas uninhabitable.
31 December 2010 in Bulletin of the New Zealand Society for Earthquake Engineering
On 4 September 2010, a magnitude Mw 7.1 earthquake struck the Canterbury region on the South Island of New Zealand. The epicentre of the earthquake was located in the Darfield area about 40 km west of the city of Christchurch. Extensive damage was inflicted to lifelines and residential houses due to widespread liquefaction and lateral spreading in areas close to major streams, rivers and wetlands throughout Christchurch and Kaiapoi. Unreinforced masonry buildings also suffered extensive damage throughout the region. Despite the severe damage to infrastructure and residential houses, fortunately, no deaths occurred and only two injuries were reported in this earthquake. From an engineering viewpoint, one may argue that the most significant aspects of the 2010 Darfield Earthquake were geotechnical in nature, with liquefaction and lateral spreading being the principal culprits for the inflicted damage. Following the earthquake, an intensive geotechnical reconnaissance was conducted to capture evidence and perishable data from this event. The surveys were performed on foot, by car and from a helicopter over a period of six days. A broad-brush field reconnaissance was conducted in the first two days, followed by pin-point investigations at specific locations including detailed site inspections and field testing using: Dynamic Cone Penetration Test (DCPT), Swedish Weight Sounding (SWS), and Spectral Analysis of Surface Waves (SASW). This paper summarizes the observations and preliminary findings from this early reconnaissance work.
13 August 2012 in New Zealand Journal of Geology and Geophysics
In the 4 September 2010 ( M W =7.1) and 22 February 2011 ( M W =6.2) earthquakes, widespread liquefaction and lateral spreading occurred throughout Christchurch and the town of Kaiapoi. The severe soil liquefaction and lateral spreading in particular caused extensive and heavy damage to residential buildings, Christchurch business district (CBD) buildings, bridges and water supply and wastewater systems of Christchurch. After the earthquake, comprehensive field investigations and inspections were conducted to document the liquefaction‐induced land damage and lateral spreading displacements and their impact on buildings and infrastructure. The results of ground surveying measurements of lateral spreads at approximately 120 locations along the Avon River, Kaiapoi River and streams in the affected area reveal permanent lateral ground displacements at the banks of up to 2–3 m that progressed inland as far as 200–250 m from the waterway, causing significant damage to structures located within the spreading zone. Different features and magnitudes of spreading were identified, which were often affected by a complex interplay of ground conditions, topography, meandering river geometry and local depositional environment. The spreading was characterised by very large and highly non‐uniform ground deformation causing stretching of building foundations and the buildings themselves. Road bridges suffered a characteristic spreading‐induced damage mechanism including back‐rotation of the abutments associated with deck pinning and damage at the top of the abutment piles. The wastewater system of Christchurch was hit particularly hard by the liquefaction and lateral spreading, and approximately 60% of the damaged pipes of the potable water system were located in areas of severe liquefaction and lateral spreading.
30 June 2017 in Bulletin of the New Zealand Society for Earthquake Engineering
CTChristopher De La Torre
+2
Widespread liquefaction occurred in the end-dumped gravelly fills and hydraulically-placed dredged sandy fill at the CentrePort of Wellington as a result of the 14 November 2016 Mw7.8 Kaikoura earthquake. This liquefaction resulted in substantial global (mass) settlement and lateral movement (spreading) of the fills towards the sea, which adversely affected wharf structures and buildings constructed on shallow and deep foundations. This paper presents key observations from the QuakeCoRE-GEER post-earthquake reconnaissance efforts at the CentrePort Wellington. The different materials and methods used to construct the reclaimed land at CentrePort influenced the patterns of observed liquefaction and its effects. Areas of gravel liquefaction at the port are especially important due to the limited number of these case histories in the literature. Liquefaction-induced ground deformations caused the wharves to displace laterally and damage their piles and offloading equipment. Lateral ground extension and differential settlement damaged buildings, whereas buildings in areas of uniform ground settlement without lateral extension performed significantly better.
30 June 2009 in Bulletin of the New Zealand Society for Earthquake Engineering
In order to incorporate seismic risk of facilities into a decision making framework, procedures are needed to quantify such risk for stakeholders. Seismic loss estimation methods combine seismic hazard, structural response, damage fragility, and damage consequences to allow quantification of seismic risk. This paper presents a loss estimation methodology which provides various measures of seismic risk for a specific facility. The methodology is component-based and can therefore distinguish between different structural configurations or different facility contents and is consistent with state-of-the-art loss assessment procedures. Loss is measured in the forms of direct structural and non-structural repair costs, and although not considered in the example, business disruption and occupant injuries can also be considered. This framework has been packaged in a computer code available for future dissemination in the public domain so that users need only to have a basic understanding of the methodology and the input data that is required. Discussion is given to the flexibility of the framework in terms of the rigour which can be employed at each of the main steps in the procedure. Via a case study of a high-rise office building, the use of the methodology in decision-making is illustrated. Methodological requirements and further research directions are discussed.