Magnesium oxide (MgO) is a major component of the Earth’s mantle and is expected to play a similar role in the mantles of large rocky exoplanets. At extreme pressures, MgO transitions from the NaCl B 1 crystal structure to a CsCl B 2 structure, which may have implications for exoplanetary deep mantle dynamics. In this study, we constrain the phase diagram of MgO with laser-compression along the shock Hugoniot, with simultaneous measurements of crystal structure, density, pressure, and temperature. We identify the B 1 to B 2 phase transition between 397 and 425 gigapascal (around 9700 kelvin), in agreement with recent theory that accounts for phonon anharmonicity. From 425 to 493 gigapascal, we observe a mixed-phase region of B1 and B2 coexistence. The transformation follows the Watanabe-Tokonami-Morimoto mechanism. Our data are consistent with B 2-liquid coexistence above 500 gigapascal and complete melting at 634 gigapascal. This study bridges the gap between previous theoretical and experimental studies, providing insights into the timescale of this phase transition.

Laser-driven shock compression enables an experimental study of phase transitions at unprecedented pressures and temperatures. One example is the shock Hugoniot of magnesium oxide (MgO), which crosses the B1–B2-liquid triple point at 400–600 GPa, 10 000–13 000 K (0.86–1.12 eV). MgO is a major component within the mantles of terrestrial planets and has long been a focus of high-pressure research. Here, we combine time-resolved velocimetry and pyrometry measurements with a decaying shock platform to obtain pressure–temperature data on MgO from 300 to 1500 GPa and 9000 to 50 000 K. Pressure–temperature–density Hugoniot data are reported at 1500 GPa. These data represent the near-instantaneous response of an MgO [100] single crystal to shock compression. We report on a prominent temperature anomaly between 400 and 460 GPa, in general agreement with previous shock studies, and draw comparison with equation-of-state models. We provide a detailed analysis of the decaying shock compression platform, including a treatment of a pressure-dependent optical depth near the shock front. We show that if the optical depth of the shocked material is larger than 1 μm, treating the shock front as an optically thick gray body will lead to a noticeable overestimation of the shock temperature.

Alumina (Al₂O₃) is an important ceramic material notable for its compressive strength and hardness. It represents one of the major oxide components of the Earth’s mantle. Static compression experiments have reported evidence for phase transformations from the trigonal α-corundum phase to the orthorhombic Rh₂O₃(II)-type structure at ∼90 GPa, and then to the post-perovskite structure at ∼130 GPa, but these phases have yet to be directly observed under shock compression. In this work, we describe laser-driven shock compression experiments on polycrystalline alumina conducted at the Matter in Extreme Conditions endstation of the Linac Coherent Light Source. Ultrafast x-ray pulses (50 fs, 10¹² photons/pulse) were used to probe the atomic-level response at different times during shock propagation and subsequent pressure release. At 107 ± 8 GPa on the Hugoniot, we observe diffraction peaks that match the orthorhombic Rh₂O₃(II) phase with a density of 5.16 ± 0.03 g cm⁻³. Upon unloading, the material transforms back to the α-corundum structure. Upon release to ambient pressure, densities are lower than predicted assuming isentropic release, indicating additional lattice expansion due to plastic work heating. Using temperature values calculated from density measurements, we provide an estimate of alumina’s strength on release from shock compression.

The high-entropy alloy with composition AlCoCrFeNi2.1, additively manufactured with the laser powder-bed fusion technique, has a far-from-equilibrium BCC/FCC eutectic nanolamellar structure. We studied the high-pressure response of this alloy under both static compression and high-strain rate shock compression. The response to static compression using a diamond anvil cell was studied at pressures up to 302 GPa with synchrotron x-ray diffraction at the advanced photon source. The high-pressure FCC-only phase of the EHEA previously observed by Pope et al. [AIP Adv. 13, 035124 (2023)] is found to be stable up to the highest pressure achieved in this study with a volume compression of V/V0 = 0.587 at ambient temperature. The shock experiments were performed by using GEKKO XII lasers at the Institute of Laser Engineering, Osaka University. The principal Hugoniot equation-of-state of the EHEA was measured up to a pressure of 515 GPa and a compression of V/V0 = 0.613. Additionally, the thermal equation of state of the EHEA was measured up to 6.2 GPa and 1623 K using a large-volume Paris–Edinburgh cell to obtain the temperature dependence of bulk modulus and thermal expansion coefficients. The melting temperature for EHEA AlCoCrFeNi2.1 at a pressure of 5.6 GPa was measured to be 1648 ± 25 K. These results can be used to refine stochastic (or special) quasi-random structure (SQS) models for high-pressure high-temperature behavior of high-entropy alloys.

This work investigates the high-pressure behavior of α-furil. At ∼1.6 GPa α-furil transforms into the previously theorized trans -planar conformation before undergoing a Diels–Alder reaction to form chemically homogeneous “double-core” nanothreads.

The phase stability, crystal structure, and melting of Nb have been examined under high pressure shock compression to 365 GPa using ultrafast x-ray diffraction measurements on two x-ray free electron laser facilities. On compression, Nb remains stable in the bcc phase up to 220 GPa, with coexistence of bcc-Nb and liquid from 249 to 298 GPa, and complete melting at 301 GPa, with melt identified by diffuse liquid diffraction. Melting initiates at higher pressure than expected based on theoretical predictions, and the data consistently excludes the presence of other suggested phases of Nb at these pressures, including and hcp, thereby resolving the long-standing structural discrepancy. Singh-type strength analysis provides experimental evidence for a change in sign of the elastic anisotropy parameter at 121 GPa, consistent with the previously reported heat-induced hardening to heat-induced softening transition in Nb.