1 October 2008 in Journal of Aerospace Information Systems
This paper presents a fully autonomous multisensor anti-collision system for Unmanned Aerial Vehicles (UAVs). This system is being developed by the Italian Aerospace Research Center (CIRA) in collaboration with the Dept. of Aerospace Engineering of the University of Naples “Federico II”, within a research project named TECVOL, funded in the frame of the National Aerospace Research Program (PRO.R.A.) on UAV. The system prototype will be initially installed onboard a manned laboratory aircraft equipped for automatic control so that flight tests will verify the adequacy of attained performances for supporting fully autonomous flight. In order to perform the obstacle detection and identification function, a multisensor configuration has been designed in the TECVOL preliminary studies. The hardware configuration is made up by a pulsed Ka-band radar, two visible (panchromatic and colour) videocameras, two infrared (IR) videocameras, and two computers, one dedicated to sensor fusion and communication with the flight control computer and with the radar, the other devoted to image processing. They are connected to the Flight Control Computer by means of a deterministic data bus. On the basis of these tracking estimates and of a Collision Avoidance Software, the GNC computer generates and follows in real time a proper escape trajectory. In order to evaluate the performance of the entire collision avoidance system, numerical simulations have been performed taking into account the DS&A sensors’ accuracy, UAV’s and intruder’s flight dynamics, navigation system accuracy and latencies, collision avoidance logic, and practical real-time implementation issues. The relevant results helped to assess overall system performances. They are discussed in depth at the end of the paper
14 March 2011 in IEEE Transactions on Geoscience and Remote Sensing
This paper analyzes the spatial resolution of bistatic synthetic aperture radar (SAR) in general hybrid configurations, such as air- and spaceborne systems moving along independent trajectories. The gradient method is utilized to point out the effects of the acquisition geometry, namely, position and velocity of both the transmitter and the receiver, on image resolution. This general approach is applied to different realizations of bistatic SAR, such as low-Earth-orbit monostatic-bistatic SAR, spaceborne-airborne bistatic SAR, and a bistatic system consisting of a high-altitude long-endurance illuminator and lower altitude airborne receivers. The main features of the method are then put in evidence, including the derivation of analytical tools to individuate adequate relative geometries for achieving satisfactory resolutions. A comparison to the other proposed techniques for computing the spatial resolution of bistatic SAR is also reported in order to highlight some peculiarities of all presented methodologies. Finally, the good agreement between the image resolution results achieved by recently carried out bistatic SAR experiments and the ones derived by the gradient method strengthens the potentialities of the proposed approach.
9 August 2010 in IEEE Transactions on Aerospace and Electronic Systems
Starting from the reborn international interest in lunar exploration and the widely documented need for hyper-accurate measurements of Earth crustal dynamics, at a high revisit frequency and on a global scale, the idea of a Moon-based interferometric synthetic aperture radar (SAR) is presented. After introducing models to describe synthetic antenna formation and discussing key issues of a Moon-based radar for Earth remote sensing, a preliminary system design and performance analysis are conducted. Quantitative results are presented in terms of achievable resolutions and needed radar parameters. Although the Moon-based observatory requires technical solutions and a budget that likely make its realization distant, a comparison with currently planned spaceborne interferometric systems shows that it offers height measurement accuracies at a level and with a frequency not achievable otherwise.
1 January 1998 in IEEE Transactions on Geoscience and Remote Sensing
This paper presents an application of the European Remote Sensing (ERS) satellites' radar data to digital elevation model (DEM) generation. The selected test site is the Sannio-Matese area in southern Italy, where several corner reflectors (CRs) were deployed to be used as ground control points (GCPs) for height measurement accuracy validation. First of all, an analysis of the CR response in radar images is presented. Then, the procedure for image pair geometric registration and interferogram formation is described in detail. A quantitative analysis is also performed by comparing these interferograms to the corresponding products obtained by using the ISAR software, officially distributed by the European Space Agency (ESA). Reported correlation values show that only tandem pairs allow an efficient interferometric processing to be performed, thanks to their short-time baseline (one day), whereas correlation adequate for differential interferometry could not be achieved. The method adopted for the computation of the interferometric baseline components on the basis of satellite orbital data is described, including the GCP-based corrections. The procedure was applied to obtain DEMs of a 10×10 km2 subarea characterized by very high correlation coefficients (0.6). The best attained values of the GCP height measurement accuracy were about 4 m. Finally, the DEMs were compared, giving root mean square (rms) differences less than 20 m in the best case
1 January 2001 in IEEE Transactions on Aerospace and Electronic Systems
A system study of a spaceborne along-track synthetic aperture radar (SAR) interferometer is presented. This sensor has been successfully experienced for detecting moving targets by using only airborne installations. Several key issues must be addressed when spaceborne configurations are envisaged. To this end, a quantitative evaluation of system performance and measurement accuracy has been conducted. First, the identification of possible space configurations has been accomplished. In particular, the two antennas can operate on a single satellite or they can be carried along appropriate trajectories by two spacecrafts. Then, an error budget of radial velocity measurement accuracy has been performed. Finally, two possible mission scenarios are dealt in details, and numerical results are reported.