Immobilization of spent electrolyte–radioactive waste (RW) generated during the pyrochemical processing of mixed nitride uranium–plutonium spent nuclear fuel is an acute task for further development of the closed nuclear fuel cycle with fast neutron reactors. The electrolyte is a mixture of chloride salts that cannot be immobilized directly in conventional cement or glass matrix. In this work, a low-temperature magnesium potassium phosphate (MPP) matrix and two types of high-temperature matrices (sodium aluminoironphosphate (NAFP) glass and ceramics based on bentonite clay) were synthesized. Two systems (Li0.4K0.28La0.08Cs0.016Sr0.016Ba0.016Cl and Li0.56K0.40Cs0.02Sr0.02Cl) were used as spent electrolyte imitators. The phase composition and structure of obtained materials were studied by XRD and SEM-EDS methods. The differential leaching rate of Cs from MPP compound and ceramic based on bentonite clay was about 10−5 g/(cm2·day), and the rate of Na from NAFP glass was about 10−6 g/(cm2·day). The rate of 239Pu from MPP compound (leaching at 25 °C) and NAFP glass (leaching at 90 °C) was about 10−6 and 10−7 g/(cm2·day), respectively. All the synthesized materials demonstrated high hydrolytic, mechanical compression strength (40–50 MPa) even after thermal (up to 450 °C) and irradiation (up to 109 Gy) tests. The characteristics of the studied matrices correspond to the current requirements to immobilized high-level RW, that allow us to suggest these materials for industrial processing of the spent electrolyte.
Samples of sodium aluminum iron phosphate glass were synthesized containing rhenium as a surrogate of technetium from radioactive waste. The phase composition, structure and water resistance of the obtained glasses were investigated. It was shown that the samples with the rhenium oxide inclusion up to 2.88 wt % are X-ray amorphous and homogeneous, and their anionic motif corresponds to the glassy one. It was found that the oxidation state of rhenium in the obtained glasses is Re(VII), and 97% of iron is in the form of Fe(III) and 3% in the form of Fe(II). The glass was established to be highly resistant to leaching at 90°C. The rate of Re leaching from glasses in accordance with the international product consistency test (PCT) and the semi-dynamic test of State Standard GOST R 52126-2003 is no more than 6 × 10–6 and 3 × 10–6 g/(cm2 day), respectively.
The key task in the solidification of high-level waste (HLW) into a magnesium potassium phosphate (MPP) compound is the immobilization of mobile cesium isotopes, the activity of which provides the main contribution to the total HLW activity. In addition, the obtained compound containing heat-generating radionuclides can be significantly heated, which increases the necessity of its thermal stability. The current work is aimed at assessing the impact of various methodological approaches to HLW solidification on the thermal stability of the MPP compound, which is evaluated by the mechanical strength of the compound and its resistance to cesium leaching. High-salt surrogate HLW solution (S-HLW) used in the investigation was prepared for solidification by adding sorbents of various types binding at least 93% of 137Cs: ferrocyanide K-Ni (FKN), natural zeolite (NZ), synthetic zeolite Na-mordenite (MOR), and silicotungstic acid (STA). Prepared S-HLW was solidified into the MPP compound. Wollastonite (W) and NZ as fillers were added to the compound composition in the case of using FKN and STA, respectively. It was found that heat treatment up to 450 °C of the compound containing FKN and W (MPP-FKN-W) almost did not affect its compressive strength (about 12–19 МPa), and it led to a decrease of high compressive strength (40–50 MPa) of the compounds containing NZ, MOR, and STA (MPP-NZ, MPP-MOR, and MPP-STA-NZ, respectively) by an average of 2–3 times. It was shown that the differential leaching rate of 137Cs on the 28th day from MPP-FKN-W after heating to 250 °C was 5.3 × 10−6 g/(cm2∙day), however, at a higher temperature, it increased by 20 and more times. The differential leaching rate of 137Cs from MPP-NZ, MPP-MOR, and MPP-STA-NZ had values of (2.9–11) × 10−5 g/(cm2∙day), while the dependence on the heat treatment temperature of the compound was negligible.
Structural properties and water dissolution of six sodium–aluminum–phosphate (NAP) glasses have been investigated before and after irradiation by a gamma-ray source based on 60Co. Two of these samples were of simple composition, and four samples had a complex composition with radionuclide simulants representing actinides, fission, and activated corrosion products. Samples of the simple composition are fully vitreous, whereas samples of the complex composition contained up to 10 vol.% of aluminum–phosphate, AlPO4, and traces of ruthenium dioxide, RuO2. Based on the study of pristine and irradiated glasses, it was established that the radiation dose of 62 million Gray had practically no effect on the phase composition and structure of samples. At the same time, the rate of leaching of elements from the irradiated samples by water was decreased by about two times.
Samples of aluminum (iron) phosphate glasses containing weighable amounts of rare earth and transuranium elements were synthesized. The quenched glasses obtained are X-ray amorphous, and in the...