1 June 2008 in Australasian Physics & Engineering Sciences in Medicine
16 November 2011 in Osteoporosis International
1 November 2007 in Journal of Bone and Mineral Research
Copyright © 2007 American Society for Bone and Mineral ResearchUNLABELLED: The aim of this study was to investigate the effects of overload in orthogonal directions on longitudinal and transverse mechanical integrity in human vertebral trabecular bone. Results suggest that the trabecular structure has properties that act to minimize the decrease of apparent toughness transverse to the primary loading direction. INTRODUCTION: The maintenance of mechanical integrity and function of trabecular structure after overload remains largely unexplored. Whereas a number of studies have focused on addressing the question by testing the principal anatomical loading direction, the mechanical anisotropy has been overlooked. The aim of this study was to investigate the effects of overload in orthogonal directions on longitudinal and transverse mechanical integrity in human vertebral trabecular bone. MATERIALS AND METHODS: T(12)/L(1) vertebral bodies from five cases and L(4)/L(5) vertebral bodies from seven cases were retrieved at autopsy. A cube of trabecular bone was cut from the centrum of each vertebral body and imaged by microCT. Cubes from each T(12)/L(1) and L(4)/L(5) pairs were assigned to either superoinferior (SI) or anteroposterior (AP) mechanical testing groups. All samples were mechanically tested to 10% apparent strain by uniaxial compression according to their SI or AP allocation. To elucidate the extent to which overload in orthogonal directions affects the mechanical integrity of the trabecular structure, samples were retested (after initial uniaxial compression) in their orthogonal direction. After mechanical testing in each direction, apparent ultimate failure stresses (UFS), apparent elastic moduli (E), and apparent toughness moduli (u) were computed. RESULTS: Significant differences in mechanical properties were found between SI and AP directions in both first and second overload tests. Mechanical anisotropy far exceeded differences resulting from overloading the structure in the orthogonal direction. No significant differences were found in mean UFS and mean u for the first or second overload tests. A significant decrease of 35% was identified in mean E for cubes overloaded in the SI direction and then overloaded in the AP direction. CONCLUSIONS: Observed differences in the mechanics of trabecular structure after overload suggests that the trabecular structure has properties that act to minimize loss of apparent toughness, perhaps through energy dissipating sacrificial structures transverse to the primary loading direction.Arash Badiei, Murk J. Bottema and Nicola L. Fazzalar
29 January 2019 in Respirology Case Reports
Pleural infection as a complication of ascending urological infection is rare, and the mechanism often unclear. We report a complicated case of pleural infection and perinephric abscess in a patient who presented with a large right‐sided pleural effusion. Pleural fluid culture yielded Morganella morganii, an unusual pathogen in pleuro‐pulmonary infections. Her computed tomography (CT) scan of abdomen showed a right perinephric abscess which extended into the pleural cavity. Review of prior CT imaging suggested a pre‐existing diaphragmatic defect, likely representing a congenital Bochdalek foramen, through which the infection ascended. Successful treatment was achieved with systemic antibiotics, and drainage of both the pleural and retroperitoneal collections. Intra‐pleural tissue plasminogen activator/deoxyribonuclease therapy effectively cleared the residual pleural fluid. Spread of intra‐abdominal sepsis through diaphragmatic defects to the pleural cavity represents a potential source of empyema.
30 September 2019 in Internal Medicine Journal