19 February 2003 in IEEE Transactions on Magnetics
This paper develops a numerical model for calculation of eddy-current losses in a multiturn winding of a high-frequency transformer. The model assumes periodic arrangement of conductors, and uses the repeat elementary cell concept. The paper proposes analytical expressions and graphic dependences to determine effective frequency-dependent resistance of the winding. It computes the leakage field in the transformer window, taking into consideration the effective magnetic permeability of the multiturn winding as a heterogeneous medium. Finally, it analyzes the values of the resistance at various frequencies for two types of winding (solid conductor winding and Litz wire winding) by numerical and experimental methods.
20 December 2010 in Applied Physics Letters
By examining two types of lateral InGaN/GaN light emitting diodes with different contact patterns, we demonstrate that in the intermediate range of current where the space-charge region dominates in the device performance, the ideality factor increases from 1.9 (current spreading design) up to 2.4 (current crowding design). This modification of -factor could be erroneously treated as the change of free carrier recombination nature. The current crowding design is also responsible for the local overheating and heavier efficiency droop that occurs at the characteristic current 2.3 times smaller in comparison with the current spreading design.
23 April 2007 in IEEE Transactions on Magnetics
KAK. G. N. B. Abeywickrama
We present a 3-D model for calculating magnetic fields in a power transformer and the effective parameters (inductance and resistance) of its windings. The transformer is representative of large transformers with power ratings ranging from hundreds of kilovolt amperes to hundreds of megavolt amperes. The model accounts for anisotropic frequency-dependent properties of the laminated transformer core and eddy currents in the steel sheets. We discuss the results of the calculations performed in the frequency range 10 Hz-10 MHz, and show that the largest variations of both the magnetic field and parameters of the windings take place at frequencies below ~10 kHz and, at frequencies higher than 1 MHz, the magnetic core does not significantly affect the variation of the effective parameters
22 October 2007 in IEEE Transactions on Magnetics
KAK. G. Nilanga B. Abeywickrama
K. G. Nilanga B. Abeywickrama
We propose a hierarchical multiscale approach to modeling of high-frequency phenomena in power transformers. The method is based on considering high-frequency effects on two spatial levels. Part I of the paper focuses on a small-scale level where eddy-current as well as geometrical and proximity effects in conductors of transformer windings are examined. It develops a computer model that accounts for anisotropic frequency-dependent diamagnetic properties of transformer windings, which are represented as composite media with periodic structure. Calculations of effective characteristics of the laminated transformer core take into account anisotropic magnetic properties of steel sheets. The frequency-dependent parameters of transformer elements thus obtained will be further used in Part II for computing effective inductances and resistances of windings and integral losses on a large-scale level, i.e., for the whole transformer.
17 December 2001 in Applied Physics Letters
High-resolution two-dimensional infrared (IR) imaging of dynamic electronic processes in the surface-emitting p-InAsSb/n-InAsSbP light-emitting diodes (LEDs) (λ=4.3 μm, T>300 K) showed that forward current crowding drastically decreases efficiency of LEDs with point contacts. Current flows and IR emittance “forget” the emitting area size and geometry, whereas extended areas far off the point contacts become even “darker” with the current increase. Contrary to this, the reverse bias causes remarkable current spreading and uniform “negative emittance” distribution. Therefore the negative luminescence mode is more favorable for IR LEDs operating at higher temperatures.
1 January 2012 in Procedia Engineering
There has been developed a mathematical model for analyzing the magnetic field in the core of magnetic-fluid seal (MFS) with account of nonlinear magnetic properties of the materials for magnetic core and shaft. To provide for the numerical realization of this model, there was used a finite-element method and Comsol software package