19 August 2022 in Ceramics International
22 January 2021 in Journal of Physics D: Applied Physics
MoS 2 -based transition metal dichalcogenide nanoflowers are synthesized using the hydrothermal method and their potential as a counter electrode in dye-sensitized solar cells (DSSCs) is examined. Structural analysis of synthesized MoS 2 is analysed using x-ray diffraction spectra and Raman spectroscopy. The morphology and microstructural properties are investigated using field-emission scanning electron microscopy and high-resolution transmission electron microscopy, respectively. DSSCs are fabricated using different counter electrodes (MoS 2 , MoS 2 -carbon black and MoS 2 -high conductive carbon paste (HCP)), which are deposited using a simple spin-coating method and annealed at a temperature of 80 °C. The electrochemical properties of the fabricated counter electrodes are studied using electrochemical impedance spectroscopy. Among the different counter electrodes, MoS 2 –HCP shows better electrochemical performance. The high electrocatalytic and conducting nature of the MoS 2 –HCP-based counter electrode produces 5% power conversion efficiency, which is comparable to expensive Pt-based counter electrodes (5.4%). To demonstrate the bifacial concept of DSSC, 2.2% power conversion efficiency is attained with rear-side illumination under one sun (100 mW cm −2 , AM 1.5 G).
1 June 2021 in Materials Today Communications
15 May 2019 in Materials Research Express
7 October 2026 in SSRN Electronic Journal
MRMuthukumar Rajamanickam
Multi-crystalline silicon ingots are mainly created by a widely recognized directional solidification process. The directional solidification technique established on copper plates was used for producing the boron-doped multi-crystalline silicon (mc-Si) ingots. In order to generate multicrystalline silicon, a novel design of copper plate created directed solidification furnace is suggested based on numerical simulation. In an experiment, grown ingots were used to make bricks, followed by wafers. The wafers are subjected to primary elemental analyses, including surface morphology, UV analysis, and XRD analysis. The influence of copper plate design as a quick cooling mechanism is investigated in this article using numerical simulation. The melt-crystal interface, heat flux, stress level and dislocation in the mc-silicon ingot at the final stage of the solidification process are all impacted by this development. The results are compared than that of with copper plate system and without copper plate system. The result demonstrates that the copper plate created DS system may yield greater crystal quality.