12 June 2023 in Applied Optics
Baseline correction is necessary for the qualitative and quantitative analysis of samples because of the existence of background fluorescence interference in Raman spectra. The asymmetric least squares (ALS) method is an adaptive and automated algorithm that avoids peak detection operations along with other user interactions. However, current ALS-based improved algorithms only consider the smoothness configuration of regions where the signals are greater than the fitted baseline, which results in smoothing distortion. In this paper, an asymmetrically reweighted penalized least squares method based on spectral estimation (SEALS) is proposed. SEALS considers not only the uniform distribution of additive noise along the baseline but also the energy distribution of the signal above and below the fitted baseline. The energy distribution is estimated using inverse Fourier and autoregressive models to create a spectral estimation kernel. This kernel effectively optimizes and balances the asymmetric weight assigned to each data point. By doing so, it resolves the issue of local oversmoothing that is typically encountered in the asymmetrically reweighted penalized least squares method. This oversmoothing problem can negatively impact the iteration depth and accuracy of baseline fitting. In comparative experiments on simulated spectra, SEALS demonstrated a better baseline fitting performance compared to several other advanced baseline correction methods, both under moderate and strong fluorescence backgrounds. It has also been proven to be highly resistant to noise interference. When applied to real Raman spectra, the algorithm correctly restored the weak peaks and removed the fluorescence peaks, demonstrating the effectiveness of this method. The computation time of the proposed method was approximately 0.05 s, which satisfies the real-time baseline correction requirements of practical spectroscopy acquisition.
20 September 2022 in Analytical Methods
Unsupervised deep learning methods place increased emphasis on the process of cluster analysis of unknown samples without requiring sample labels.
25 October 2021 in Journal of Raman Spectroscopy
Although ultraviolet (UV) laser Raman spectroscopy offers the benefits of stronger signals, partial separation of fluorescence and Raman spectra, and increased eye safety, it suffers from excessive noise, poor resolution, low maturity level, and small intensities of remotely acquired signals and therefore needs to be used in combination with effective denoising techniques. Herein, a denoising approach denoted as iterative differential autoregressive spectrum estimation was developed relying on the assumption that more detailed Raman peaks can be obtained by dividing the Raman spectrum into multiple layers with different intensity levels and estimating the energy distribution of each layer. Specifically, each layer was computed from the difference between the upper layer spectrum and its autoregressive model estimation spectrum, and the energy distribution at progressively lower intensity levels was considered. Compared with traditional techniques, our method exhibited good noise suppression performance and an excellent Raman peak restoration ability while offering the advantages of decreased spectral resolution loss and stable robustness. Cutoff optimization strategies were proposed to improve convergence and noise suppression ability and thus decrease the calculation time to 0.18 s and meet the needs of remote Raman spectrometers for real‐time denoising under the condition of long integration. The developed technique paves the way to Raman spectrum denoising based on power spectrum estimation, has a strong adaptive potential, and can be extended to other applications.