Organic thermoelectrics are emerging as strong candidates for micro energy harvesting devices to power low energy electronics and serve as sustainable distributed energy supplies. Here their actual potential is assessed with respect to different applications scenarios, such as wearables and sensors networks, providing useful guidelines for their future development.
Optimizing electrode morphology with a more uniform ionomer distribution is key to reducing ohmic losses and increasing electrocatalyst utilization in polymer electrolyte fuel cells (PEFCs). Inherent ionomer conductivity, volume fraction and tortuosity determine effective ionic conductivity. We use hydrogen pump (HP) method to measure effective ionic conductivity of a pseudo catalyst layer (PCL) comprised of Vulcan XC-72 carbon black and 3M 825 EW ionomer with ionomer to carbon (I/C) ratios of 0.6, 1 and 1.4 and relative humidity (RH) range of 50 to 120%. These direct current (DC) experiments are then compared with electrochemical impedance spectroscopy (EIS). Both DC and EIS methods show good agreement, indicating that EIS can be used as an alternative to DC method in HP experiment. Ionic conductivity for PCL with I/C of 1 and 1.4 was found to be about one order of magnitude higher than I/C of 0.6 for most of the RH range. At 90% RH tortuosities for I/C = 1 and 1.4 were close to 1, whereas tortuosity for I/C = 0.6 was 3. With decrease in relative humidity tortuosities increased linearly and at 50% relative humidity a PCL with I/C = 0.6 had the highest tortuosity of 6.1.
30 April 2021 in Journal of the Electrochemical Society
A cathode catalyst layer containing optimally distributed ionomer is critical to reduce the platinum loading and increase its utilization in polymer electrolyte fuel cells. Here, electrochemical impedance spectroscopy (EIS) was used to measure effective ionic conductivity of pseudo catalyst layers (PCLs) at a relative humidity (RH) range of 50%–120%. These results are compared to previous work using the hydrogen pump (HP) method. EIS effective ionic conductivity results reported here are higher than those from the HP because in the HP set-up ionic pathways must be effectively connected through the PCL to be counted, whereas in the EIS measurement, ionomer segments that are in contact with the membrane but are not effectively connected all the way through the PCL can be detected. Double layer capacitances and effective ionic conductivities of Pt/C catalyst layers with various supports and ionomer to carbon (I/C) ratios were studied. High surface area carbon support resulted in a lower effective ionic conductivity compared to the graphitized carbon support due to worse ionomer dispersion. Effective ionic conductivities of Pt/C layers were compared to that of PCLs. On average, effective ionic conductivities of Pt/C layers were higher than PCLs because of possible carbon agglomeration within the PCLs.
The properties of the excited states of , populated in the decay of produced at ISOLDE isotopic separator, have been investigated by using K-conversion electron, γ-ray, and γ-γ coincidence measurements. The lifetimes of several levels have been measured by means of the advanced time-delayed method. The identification of 19 new levels and 55 transitions and the information deduced on spin and/or parity of the observed states from K-conversion coefficients, log ft values and decay properties have led to an improved knowledge of the level scheme. In particular, six states have been definitely identified and has been assigned to the 2227 keV level, on which a band proposed to have negative-parity and even-spin had been previously observed. The strengths of the E0 and E2 transitions deexciting the and states (the latter is here identified with the state at 1598 keV) have been measured. The experimental data concerning the state have been analyzed in a simple two states mixing model and in the framework of the proton-neutron interacting boson model.