Modifications to the aqueous solution self-assembly and thermoresponsive properties of poly(N-isopropylacrylamide) (PNIPAm) can be achieved by hydrophobic end-group functionalization and incorporation of hydrophilic N,N-dimethylacrylamide (DMA) repeat units. Although these variations have been studied separately in the past, the simultaneous effects of both modifications have not been investigated systematically. Herein, we report the synthesis of six NIPAM and DMA based statistical, ABA triblock, and ABABA pentablock copolymers using reversible addition–fragmentation chain transfer (RAFT) polymerization, each containing one or two dodecyl hydrocarbon end-groups. Assembly into nanoscale particles and thermoresponsive properties in phosphate buffered saline were studied using light scattering and diffusion ordered NMR spectroscopy. Cloud points (Tcp) remained between 30–45 °C, notwithstanding hydrophobic modification. Copolymers with two alkyl tails assembled into flower-like micelles below the Tcp. The monofunctional statistical copolymer formed a core–shell assembly and the monofunctional ABA and ABABA polymers were molecularly dissolved. Above the Tcp, reversible precipitation was observed in all systems except for the monofunctional ABABA pentablock, which unexpectedly formed uniform large (>100 nm diameter) aggregates interpreted as mesoglobules. These results demonstrate surprising and delicately balanced tradeoffs between short non-polar end groups and tailored hydrophobicity in the nanoscale self-assembly of PNIPAm based copolymers in water near the lower critical solution temperature.
Polymeric ionic liquids (i.e., PILs) are single ion-conducting materials that exhibit the thermal and electrochemical stability of ionic liquids and the mechanical properties of polymers. Although PILs are exciting for a variety of applications in energy conversion and storage, the tradeoff between mechanics and ion transport remains an important limitation in materials design. Herein, a photocrosslinkable PIL based on the cycloaddition reaction of anthracene is converted from a viscous liquid into a soft solid without detrimental effects on the bulk ionic conductivity. The independent control of mechanical- and ion-conducting properties results from negligible changes in polymer segmental dynamics (i.e., glass transition temperature) upon crosslinking. This was demonstrated for both a polymer (i.e., N = 279) and its corresponding oligomer (i.e., N = 10). The ease of processability facilitated by the presented molecular design is illustrated by both patterning the PIL into μm-sized features, and incorporating it as a dielectric in thin-film transistors for low-voltage operation independent of device fabrication geometry.
Bioinspired iron-catechol cross-links have shown remarkable success in increasing the mechanical properties of polymer networks, in part due to clustering of Fe3+-catechol domains which act as secondary network reinforcing sites. We report a versatile synthetic procedure to prepare modular PEG-acrylate networks with independently tunable covalent bis(acrylate) and supramolecular Fe3+-catechol cross-linking. Initial control of network structure is achieved through radical polymerization and cross-linking, followed by postpolymerization incorporation of catechol units via quantitative active ester chemistry and subsequent complexation with iron salts. By tuning the ratio of each building block, dual cross-linked networks reinforced by clustered iron-catechol domains are prepared and exhibit a wide range of properties (Young's moduli up to ∼245 MPa), well beyond the values achieved through purely covalent cross-linking. This stepwise approach to mixed covalent and metal-ligand cross-linked networks also permits local patterning of PEG-based films through masking techniques forming distinct hard, soft, and gradient regions.