Some types of biological particles are known to nucleate ice at warmer temperatures than mineral dust, with the potential to influence cloud microphysical properties and climate. However, the prevalence of these particle types above the atmospheric boundary layer is not well known. Many types of biological particles fluoresce when exposed to ultraviolet light, and the Wideband Integrated Bioaerosol Sensor takes advantage of this characteristic to perform real-time measurements of fluorescent biological aerosol particles (FBAPs). This instrument was flown on the National Center for Atmospheric Research Gulfstream V aircraft to measure concentrations of fluorescent biological particles from different potential sources and at various altitudes over the US western plains in early autumn. Clear-air number concentrations of FBAPs between 0.8 and 12 µm diameter usually decreased with height and generally were about 10–100 L−1 in the continental boundary layer but always much lower at temperatures colder than 255 K in the free troposphere. At intermediate temperatures where biological ice-nucleating particles may influence mixed-phase cloud formation (255 K ≤ T ≤ 270 K), concentrations of fluorescent particles were the most variable and were occasionally near boundary-layer concentrations. Predicted vertical distributions of ice-nucleating particle concentrations based on FBAP measurements in this temperature regime sometimes reached typical concentrations of primary ice in clouds but were often much lower. If convection was assumed to lift boundary-layer FBAPs without losses to the free troposphere, better agreement between predicted ice-nucleating particle concentrations and typical ice crystal concentrations was achieved. Ice-nucleating particle concentrations were also measured during one flight and showed a decrease with height, and concentrations were consistent with a relationship to FBAPs established previously at the forested surface site below. The vertical distributions of FBAPs measured on five flights were also compared with those for bacteria, fungal spores, and pollen predicted from the EMAC global chemistry–climate model for the same geographic region.
26 September 2015 in Philosophical Transactions of the Royal Society B: Biological Sciences
Primary biological aerosol particles (PBAPs) may impact human health and aerosol-cloud-climate interactions. The role of PBAPs in the earth system is associated with large uncertainties, for example of source estimates and the atmospheric lifetime. We used a chemistry-climate model to simulate PBAPs in the atmosphere including bacteria and fungal spores. Three fungal spore emission parameterizations have been evaluated against an updated set of spore counts synthesized from observations reported in the literature. The comparison indicates an optimal fit for the emission parameterization proposed by Heald and Spracklen (2009) and adapted by Hoose et al. (2010) for particle sizes of 5 µm or 3 µm, although the model still overpredicts PBAP concentrations in some locations. The correlations between the spore count observations and meteorological parameters simulated by the model show a strong dependence on the leaf area index in non-urban areas and the specific humidity in urban areas. Additional evaluation was performed by comparing our combined bacteria and fungal spore simulations to a global dataset of fluorescent biological aerosol particle (FBAP) concentrations. The model predicts the total sum of measured PBAP concentrations relatively well, typically within a factor of two of FBAP. Further, the modeled fungal spore results deviate from the FBAP concentrations when used as a rough proxy for spores, depending on the particle size used in the parametrization. Uncertainties related to technical aspects of the FBAP and direct-counting spore measurements challenge the ability to further refine quantitative comparison on this scale. Additional long-term data of better quality are needed to improve emission parameterizations.