11 March 2021 in Bioinspiration & Biomimetics
The effect of shark skin on the boundary-layer separation process under dynamic conditions (maneuvers) has been studied experimentally. We use a foil covered with biomimetic shark skin to explore how this type of surface impacts boundary-layer dynamics in both steady and accelerating conditions. The effect of denticles is assessed via particle image velocimetry in the wake. It is shown that dynamic conditions and small-scale disturbances can mitigate boundary-layer separation through instantaneous modification of the local pressure-gradient distribution. For instance, the region of favourable pressure gradient can be extended by accelerating the foil. The acceleration results in a thinner separated shear layer on the foil surface when compared to the steady reference case. This remarkable difference indicates that local roughness (introduced through for instance biomimetic shark skin) may trigger an interaction with relatively large-scale structures in the boundary layer for effective boundary-layer control during unsteady propulsion and maneuvering.
3 September 2020 in Journal of Fluid Mechanics
An experimental study of particle–vortex interactions has been undertaken in suspensions with volume fractions up to . Time-resolved particle image velocimetry measurements using a refractive index matching technique were performed to characterize the formation and evolution of vortex rings in both unconfined and confined configurations. It is shown that vortex rings in dense suspensions are more diffuse, which results in larger vortex cores and lower maximum vorticity. Furthermore, these vortex rings remain stable during their evolution, whereby the primary vortex breakdown and the formation of secondary vortices are inhibited. Although similar to vortex rings generated at lower Reynolds numbers in pure water, further results demonstrate that the vortex-ring circulation and non-dimensional vortex-core radius in dense suspensions remain higher than those in pure water at the same equivalent Reynolds number. Thus, the modification of vortex-ring behaviour in dense suspensions cannot be described solely through a variation in the effective viscosity. Finally, unlike in pure water, the confinement does not impact the non-dimensional vortex-core radius, vortex-ring circulation and maximum vorticity in dense suspensions. This unusual result demonstrates that the dynamics of vortex rings in dense suspensions are strongly insensitive to the effect of confinement.
1 July 2018 in Physics of Fluids
In the present study, a refractive-index matching (RIM) technique using hydrogel particles was developed to quantitatively measure turbulence characteristics in dense suspensions. Compared to classic RIM methods, the use of superabsorbent polymer (SAP) material significantly simplifies experimental procedures and avoids strict experimental controls, which makes the method particularly suitable for turbulence measurements in dense suspensions. Because of the high absorbency of the approximately 1 mm SAP particles, optical visibility is achieved even in dense suspensions on the order of 20% by volume. Furthermore, the small hydrogel particle diameter allows for a particle diameter-to-integral scale ratio value of 1/20. The new method is then used to reveal the flow characteristics in decaying turbulence with suspension volume fractions up to 18.4% (the measurements pass through approximately 85 hydrogel particle-water interfaces). Evidence of turbulence attenuation in suspensions is demonstrated and attributed to the inhibition of turbulence production in said suspensions. The modulations in turbulence decay are apparent even in low suspension volume fractions (2.3%), whereas the turbulence characteristics of suspensions at higher volume fractions of 9.2% and 18.4% are observed to converge on each other.
1 November 2021 in Physics of Fluids
A comprehensive experimental campaign was conducted to characterize the dynamic runback process of wind-driven water film/rivulet flows for a better understanding of the transient surface water transport process pertinent to aircraft icing phenomena. The experimental study was conducted by using an open-circuit wind tunnel to generate laminar boundary layer airflows with different freestream wind speeds to drive thin water film/rivulet flows over a flat test plate. A digital image projection (DIP) technique was used to achieve non-intrusive, temporally and spatially resolved measurements of the film thickness distributions to characterize the dynamic runback process of the wind-driven film/rivulet flow under different test conditions. Important characteristics of the wind-driven water runback process—such as the generation of well-organized two-dimensional (i.e., 2D) and more complicated three-dimensional (i.e., 3D) surface waves at air/water interfaces, stumbling runback motion of the film/rivulet heads in “acceleration-and-deceleration” cycles, breaking up the front contact lines to form multiple rivulet flows, meandering and merging of the rivulet flows—were revealed clearly and quantitatively based on the DIP measurements. A comprehensive force balance analysis was also performed to examine the variations of the relevant forces (i.e., the excess pressure forces built inside the film/rivulet flows, aerodynamic drag forces acting on the rivulet heads, and the restraining forces due to the surface tension along the liquid contact lines) and evaluate their importance in the breakoff of the stagnated film/rivulet heads to re-start the runback process of the wind-driven film/rivulet flows.
7 November 2019 in Bioinspiration & Biomimetics
The stability of leading-edge vortices (LEVs) on a samara-inspired rotor during steady and unsteady gusty incoming flow was investigated experimentally using direct rotational speed measurements, as well as time-resolved particle image velocimetry (PIV). The blades of the samara-inspired rotor were designed to match the tip-speed ratio, the aspect ratio, and the distribution of the effective angle of attack of samara seeds to utilize LEVs similar to samara seeds. The flow around the blades of the samara-inspired rotor was compared to a reference rotor, which possesses a constant spanwise effective angle of attack, to investigate the influence of the samara-like spanwise effective angle-of-attack distribution on LEV stability. Furthermore, the unsteady performance of the samara-inspired rotor was compared to a generic low-inertia rotor that possesses blades with a constant effective angle of attack less than the stall angle. During steady rotation, the samara-inspired rotor exhibited a stably-attached LEV, while the reference rotor demonstrated unstable LEV shedding. Compared to a generic low-inertia rotor, the samara-inspired rotor demonstrated a relatively stable tip-speed ratio (λ) during the gust. Furthermore, the LEV remained stably-attached on the rotor's blades with a constant normalized circulation during the gust. Finally, the analysis of the LEV stability during the gust using the vorticity transport equation suggests that LEV stability is coupled with constant tip-speed ratio during gusts.
1 July 2019 in Journal of Fluids and Structures