Due to its fuel-efficient and environmentally friendly nature, the electrocatalytic nitrogen reduction reaction (NRR) has drawn significant attention. However, most of the catalysts reported for the NRR are noble metals or oxides, which are expensive and poorly conductive. Therefore, the development of effective electrocatalysts for nitrogen (N2) fixation under ambient conditions has become a promising field. Herein, we report fluorine-free Ti3C2Tx (T = O, OH) nanosheets with a small size (∼50–100 nm lateral size) as catalysts for the NRR. The as-prepared materials achieved a high NH3 yield (36.9 μg h−1 mgcat−1) and faradaic efficiency (9.1%) at −0.3 V vs. reversible hydrogen electrode (RHE) in 0.1 M HCl. The size effect and fluorine-free properties make the performance around two times higher than that in the case of a fluorine-based treatment. This paper inspires us to pursue the extreme size (e.g. quantum dots) of MXenes which will enhance its NRR property greatly.
Next generation wireless networks embrace mmWave technology for its high capacity. Yet, mmWave radios bear a fundamental coverage limitation due to the high directionality and propagation artifacts. In this paper, we explore an economical paradigm based on 3D printing technology for mmWave coverage expansion. We propose MilliMirror, a fully passive metasurface, which can reshape and resteer mmWave beams to anomalous directions to illuminate the coverage blind spots. We develop a closed-form model to efficiently synthesize the MilliMirror design with thousands of unit elements and across a wide frequency band. We further develop an economical process based on 3D printing and metal deposition to fabricate MilliMirror. Our field test results show that MilliMirror can effectively fill the coverage holes and operate transparently to the standard mmWave beam management protocols.
Structural supercapacitors hold promise to expand the energy capacity of a system by integrating load-bearing and energy-storage functions in a multifunctional structure, resulting in weight savings and safety improvements. Here, we develop strategies based on interfacial engineering to advance multifunctional efficiency. The structural electrodes were reinforced by coating carbon-fiber weaves with a uniquely stable conjugated redox polymer and reduced graphene oxide that raised pseudocapacitive capacitance and tensile strength. The solid polymer electrolyte was tuned to a gradient configuration, where it facilitated high ionic conductivity at the electrode-electrolyte interfaces and transitioned to a composition with high mechanical strength in the bulk for load support. The gradient design enabled the multilayer structural supercapacitors to reach state-of-the-art performance matching the level of monofunctional supercapacitors. In situ electrochemical-mechanical measurements established the device durability under mechanical loads. The structural supercapacitor was made into the hull of a model boat to demonstrate its multifunctionality.
Assembling two-dimensional (2D) nanomaterials into three-dimensional (3D) hierarchical structures with novel functions is challenging and has attracted considerable attention.