The average capacity of a single-input single-output (SISO) underwater wireless optical communication (UWOC) system with partially coherent Gaussian beams in a weak oceanic turbulence regime is investigated. An approximate analytical expression of scintillation index is derived mathematically to characterize the impact of oceanic turbulence on the propagation behavior of the partially coherent Gaussian beams. Then, the path loss caused by absorption and scattering in the ocean is numerically simulated with the Monte Carlo method. With consideration for absorption, scattering, and oceanic turbulence, the combined channel fading model is established, and the average capacity of the UWOC system (defined as the maximum mutual information between the input and output) is examined. Results show that the scintillations are reduced by decreases in propagation distance, the dissipation rate of mean-square temperature, and the ratio of the temperature and salinity contributions to the refractive index spectrum. Scintillations are also decreased by increases in source beam width, degree of partial coherence, and the dissipation rate of turbulent kinetic energy per unit mass of fluid. As a result, the average capacity of the UWOC system is enhanced. Moreover, the average capacity of the UWOC system can be promoted with the availability of channel state information at the receiver. This work will benefit the research and development of UWOC systems.
In this paper, a high-performance multi-channel heterostructure based on lattice-matched AlInN/GaN has been reported. The stacking of five heterostructures yields a high two-dimensional electron gas density of 3.67 × 1013 cm−2 and a small sheet resistance (RSH) of 74.5 Ω/sq. Compared with the AlGaN/GaN sample with the same number of heterojunctions, the AlInN/GaN sample reduces the RSH by 51.2%. Since the AlInN barrier and GaN channel are lattice-matched, the strain defects caused by piezoelectric strain can be alleviated. The high-resolution x-ray diffraction results show that the total dislocation density in AlInN/GaN multi-channels is reduced by 18.9%. The calculation models of multiple-channel heterostructures are obtained to investigate the electron population and energy band diagram, and the calculated results are roughly consistent with the experimental results. With a gate–drain spacing of 11.5 μm, the on-resistance (RON) of the AlInN/GaN multi-channel HEMT was only 2.26 Ω mm, indicating that the lattice-matched multi-channel AlInN/GaN heterostructure can substantially enhance the current drive efficiency and improve the output performance of the devices.
In this letter, we proposed a p-GaN HEMT with a double barriers cap layer (DB-HEMT) using an AlN/GaN/AlN/p-GaN gate stack. Double barriers are formed at the gate/AlN and GaN/AlN interfaces, introducing an additional barrier in the p-GaN layer to suppress the gate leakage current ( I GS ) and improve the maximum continuous operating voltage ( V GS-max ). The GaN/AlN barrier not only creates a new obstacle but also mitigates the electric field through the opposite polarized electric fields engendered by heterojunction. Consequently, holes are difficult to acquire sufficient energy to overcome this barrier and inject into the p-GaN layer, thereby greatly suppressing I GS . Simultaneously, a notable positive shift in threshold voltage ( V TH ) is observed due to the dispersion gate voltage of the AlN layer. As a result, the DB-HEMT achieves an ultra-low I GS of 2.74 × 10 -6 mA/mm at V GS = 9 V, a high V GS-max of 8.8 V with a 10-year lifetime of 1% failure and a high V TH of 2.88 V, demonstrating immense potential for power switching applications.
In this paper, the p-GaN gate AlGaN/GaN high electron mobility transistors (HEMTs) with varying combinations of gate metal work function and gate geometry are fabricated and investigate the influence of gate leakage current (IGS) on the threshold voltage (VTH) and subthreshold swing (SS). The unique dependence of VTH and SS on gate geometry for different metals is observed, which is different from traditional field-effect transistors. A novel hybrid physics model, consisting of the traditional capacitance divider model and hole injection model, is proposed to explain this phenomenon, and the results exhibit an excellent agreement with the experimental data. The holes traverse the gate/p-GaN Schottky barrier by thermal emission or tunneling and inject into the p-GaN layer, generating the IGS. Expanding upon the traditional capacitance divider model, a portion of the injected holes accumulate at the p-GaN/AlGaN interface and induce the corresponding electrons at the AlGaN/GaN heterojunction, which promotes channel conduction. Hence, the transfer curves display the correlation between IGS and VTH as well as SS. The results show that high IGS can alleviate the instability of VTH caused by the lithographic overlay error, and simultaneously optimize SS. This work offers a novel perspective for examining the turn-on mechanism of p-GaN HEMTs, thereby contributing to device design.
This work presents the temperature-dependent characteristics of the thin-barrier Al0.45Ga0.55N/GaN high electron mobility transistor (HEMT), p-type CuO gate HEMT, and high-k HfO2 metal–insulator–semiconductor HEMT (MIS-HEMT). As the temperature rises from 20 to 300 °C, the maximum trans-conductance of the HfO2 MIS-HEMT and CuO gate HEMT reduces by 56.9% and 43.2%, respectively. The sub-threshold swing of the CuO gate HEMT is smaller than that of the HfO2 device when the temperature reaches 300 °C. According to the C–V test results from 20 to 300 °C, the relative dielectric constant of CuO increases from 18.1 to 47.4, whereas HfO2 has a relatively stable dielectric constant. The calculation models are presented to investigate the effect of the dielectric constant on the drain current and the trans-conductance. The calculated results show that the maximum transconductance of the HfO2 MIS-HEMT and CuO gate HEMT decreases by 52.3% and 38.9%, respectively, which is in good agreement with the experimental results.
13 May 2024 in IEEE Transactions on Electron Devices
This article reveals the single-pulse and repetitive-pulse unclamped-inductive-switching (UIS) withstanding device model and energy loss mechanism for p-GaN high electron mobility transistor (HEMT) with Schottky type gate contact. Usually, silicon/silicon carbide (Si/SiC)-based devices dissipate the surge current from the load inductor through the avalanche process. However, p-GaN HEMT can withstand the energy by storing it in the output capacitance and dissipating it by the output capacitance loss and drain leakage current loss. The device models are proposed to describe the UIS process. The maximum current loss caused by the energy storage process of the output parasitic capacitor is about 30%. During high-voltage processes, the energy loss by leakage current is of the same order as the storing energy in the inductor, so a parallel resistor is added to the device model. The parallel resistor varies based on changes in maximum voltage and maximum current during the UIS process. The experimental results are basically consistent with the theoretical calculation results. After the repetitive UIS stresses are applied to the device, the threshold voltage shifts positively and the on-resistance increases.