Despite the advantages of membrane processes, their high energy requirement remains a major challenge. Fabrication of nanocomposite membranes by incorporating various nanomaterials in the polymer matrix has shown promise for enhancing membrane flux. In this study, we embed functionalized cellulose nanofibers (CNFs) with high aspect ratios in the polymer matrix to create hydrophilic nanochannels that reduce membrane resistance and facilitate the facile transport of water molecules through the membrane. The results showed that the incorporation of 0.1 wt % CNF into the polymer matrix did not change the membrane flux (~15 ) and Bovine Serum Albumin (BSA) Fraction V rejection, while increasing the CNF content to 0.3 wt % significantly enhanced the flux by seven times to ~100 , but the rejection was decreased to 60–70%. Such a change in membrane performance was due to the formation of hydrophilic nanochannels by the incorporation of CNF (corroborated by the SEM images), decreasing the membrane resistance, and thus enhancing the flux. When the concentration of the CNF in the membrane matrix was further increased to 0.6 wt %, no further increase in the membrane flux was observed, however, the BSA rejection was found to increase to 85%. Such an increase in the rejection was related to the electrostatic repulsion between the negatively-charged CNF-loaded nanochannels and the BSA, as demonstrated by zeta potential measurements. SEM images showed the bridging effect of the CNF in the nanochannels with high CNF contents.
14 June 2021 in IEEE Transactions on Applied Superconductivity
The high-temperature superconducting (HTS) null-flux electrodynamic suspension (EDS) system is one of the most promising solutions for high-speed transportation. In this article, a 3-D model based on the finite-element method (FEM) is established to solve the electromagnetic forces in the HTS null-flux EDS system with the commercial software COMSOL Multiphysics. The current induced in the null-flux coils and the forces on the HTS magnets were studied and compared with the results from our dynamic circuit model. The two models agree with each other with a difference of less than 6%. The FEM model can deal with 3-D geometries, allowing the analysis of complex situations, such as the eddy current in the cryostat walls. Furthermore, the model can be readily extended to solve coupled problems, including the heat and mechanical behaviors of the HTS magnets and/or the null-flux coils, which are engineering concerns in real applications.
Powerline interference in the controlled source electromagnetic method has traditionally been one of the biggest conundrums plaguing geophysicists, and its conventional denoising methods primarily include filtering and noise estimation. The filter method leaches noise at specific frequency points, which might also filter useful signals; the noise estimation method significantly eliminates interference, whereas the premise is that the noise is stable after a short time and a recorder is necessary in the field. In the present study, using the periodicity and symmetry of powerline noise, we propose a subtraction and an addition method for cancellation of the powerline noise. First, the transmitted signal is optimized so that the equivalent transmitted signal is an m sequence; then the response signal is processed by using the cancellation method; subsequently, the correlation identification is applied and finally, we solve the earth impulse response by means of the Wiener filter deconvolution method. Simulation experiments and field data tests demonstrate that the powerline noise can be well suppressed by the cancellation method proposed in the present study, so that the system identification accuracy is greatly improved. The method is simple in principle and effective in removing powerline noise, which presents a novel perspective on noise elimination for system identification.