8 November 2016 in Physical Review Letters
Graphene has a negative thermal expansion coefficient; that is, when heated, the graphene lattice shrinks. On the other hand, the substrates typically used for graphene growth, such as silicon carbide, have a positive thermal expansion coefficient. Hence, on cooling graphene on SiC, graphene expands but SiC shrinks. This mismatch will physically break the atomic bonds between graphene and SiC. We have demonstrated that a graphenelike buffer layer on SiC can be converted to a quasifreestanding monolayer graphene by a rapid-cooling treatment. The decoupling of graphene from the SiC substrate was actually effective for reducing the electric carrier scattering due to interfacial phonons. In addition, the rapidly cooled graphene obtained in this way was of high-quality, strain-free, thermally stable, and strongly hole doped. This simple, classical, but quite novel technique for obtaining quasifreestanding graphene could open a new path towards a viable graphene-based semiconductor industry.
6 April 2020 in Physical Review B
We present the electronic and structural properties of monolayer grown by pulsed-laser deposition on monolayer graphene (MLG) on SiC. The spin splitting in the valence band at was eV, as determined by angle-resolved photoemission spectroscopy. Synchrotron-based grazing-incidence in-plane x-ray diffraction (XRD) revealed the in-plane lattice constant of monolayer to be Å. This indicates a lattice compression of % relative to bulk . By using the experimentally determined graphene lattice constant ( Å), we found that a unit cell of the slightly compressed is perfectly commensurate with a graphene lattice with a mismatch below 0.03%, which could explain why the monolayer is compressed on MLG. From XRD and first-principles calculations, we conclude that the observed size of strain will affect only on the order of a few meV. In addition, angle-resolved, ultraviolet, and x-ray photoelectron spectroscopies shed light on the band alignment between and MLG/SiC and indicate electron transfer from graphene to the monolayer. As further revealed by atomic force microscopy, the island size depends on the number of carbon layers on top of the SiC substrate. This suggests that the epitaxy of favors the weak van der Waals interactions with graphene, while it is perturbed by the influence of the SiC substrate and its carbon buffer layer.
22 August 2016 in Applied Physics Letters
We have investigated the relation between the step-bunching and graphene growth phenomena on an SiC substrate. We found that only a minimum amount of step-bunching occurred during the graphene growth process with a high heating rate. On the other hand, a large amount of step-bunching occurred using a slow heating process. These results indicated that we can control the degree of step-bunching during graphene growth by controlling the heating rate. We also found that graphene coverage suppressed step bunching, which is an effective methodology not only in the graphene technology but also in the SiC-based power electronics.
9 February 2018 in NPG Asia Materials
Graphene is a single-layer carbon sheet with a honeycomb structure, and bilayer graphene consists of two graphene sheets with AB stacking. In trilayer graphene, the third graphene sheet has two possible stacking sequences, A or C, when it is overlaid on bilayer graphene. It has been theoretically predicted that trilayer graphene exhibits a variety of novel electronic properties with/without a Dirac-cone band, depending on the stacking sequence. In this regard, trilayer graphene has a high potential for widening the capability of graphene-based electronic devices. However, the difficulty of selective fabrication has hindered the progress of research. Here, we report the first success in the selective fabrication of quasi-free-standing trilayer graphene with ABA or ABC stacking grown epitaxially on hydrogen-terminated silicon carbide. Angle-resolved photoemission spectroscopy (ARPES) clearly demonstrated that our trilayer graphene with ABA stacking has a massless Dirac-like band near the Fermi level, while that with ABC stacking shows a parabolic non-Dirac-like band dispersion.
17 January 2020 in Nanotechnology
We show that boron-doped epitaxial graphene can be successfully grown by thermal decomposition of a boron carbide thin film, which can also be epitaxially grown on a silicon carbide substrate. The interfaces of B 4 C on SiC and graphene on B 4 C had a fixed orientation relation, having a local stable structure with no dangling bonds. The first carbon layer on B 4 C acts as a buffer layer, and the overlaying carbon layers are graphene. Graphene on B 4 C was highly boron doped, and the hole concentration could be controlled over a wide range of 2 × 10 13 to 2 × 10 15 cm −2 . Highly boron-doped graphene exhibited a spin-glass behavior, which suggests the presence of local antiferromagnetic ordering in the spin-frustration system. Thermal decomposition of carbides holds the promise of being a technique to obtain a new class of wafer-scale functional epitaxial graphene for various applications.
17 July 2023 in Applied Physics Letters
We here report a step unbunching phenomenon, which is the inverse of the phenomenon of step bunching. When a 4H-SiC (0001) surface is annealed at a high temperature, step bunching arises due to the different velocities of the step motion in adjacent steps, resulting in steps with a height of more than several nanometers. We found that the bunched steps, thus, obtained by hydrogen etching in an Ar/H2 atmosphere were “unbunched” into lower height steps when annealed subsequently at lower temperatures. This unbunching phenomenon can be well explained by the consequence of the competition between energetics and kinetics. Our findings provide another approach for the surface smoothing of SiC by hydrogen etching and may give significant insight into the application of SiC power devices and two-dimensional materials growth techniques in general.