1 August 2017 in Near Surface Geophysics
15 September 2020 in Journal of Geophysical Research: Oceans
The release of greenhouse gases from both natural and man‐made sites has been identified as a major cause of global climate change. Extensive work has addressed quantifying gas seeps in the terrestrial setting while little has been done to refine accurate methods for determining gas flux emerging through the seabed into the water column. This paper investigates large‐scale methane seepage from the Scanner Pockmark in the North Sea with a new methodology that integrates data from both multibeam and single‐beam acoustics, with single‐beam data covering a bandwidth (3.5 to 200 kHz) far wider than that used in previous studies, to quantify the rate of gas release from the seabed into the water column. The multibeam data imaged a distinct fork‐shaped methane plume in the water column, the upper arm of which was consistently visible in the single‐beam data, while the lower arm was only intermittently visible. Using a novel acoustic inversion method, we determine the depth‐dependent gas bubble size distribution and the gas flux for each plume arm. Our results show that the upper plume arm comprises bubbles with radii ranging from 1 to 15 mm, while the lower arm consists of smaller bubbles with radii ranging from 0.01 to 0.15 mm. We extrapolate from these estimates to calculate the gas flux from the Scanner Pockmark as between 1.6 and 2.7 × 106 kg/year (272 to 456 L/min). This range was calculated by considering uncertainties together with Monte Carlo simulation. Our improved methodology allows more accurate quantification of natural and anthropogenic gas plumes in the water column.
1 November 2021 in Marine and Petroleum Geology
1 July 2021 in International Journal of Greenhouse Gas Control
10 June 2022 in Renewable and Sustainable Energy Reviews
17 March 2017 in Geophysical Journal International
The full waveform inversion (FWI) of seismic reflection data aims to reconstruct a detailed physical properties model of the subsurface, fitting both the amplitude and the traveltime of the reflections generated at physical discontinuities in the propagation medium. Unlike reservoir-scale seismic exploration, where seismic inversion is a widely adopted remote characterization tool, ultrahigh-frequency (UHF, 0.2–4.0 kHz) multichannel marine reflection seismology is still most often limited to a qualitative interpretation of the reflections’ architecture. Here we propose an elastic FWI methodology, custom-tailored for pre-stack UHF marine data in vertically heterogeneous media to obtain a decimetric-scale distribution of P-impedance, density and Poisson’s ratio within the shallow subseabed sediments. We address the deterministic multiparameter inversion in a sequential fashion. The complex trace instantaneous phase is first inverted for the P-wave velocity to make up for the lack of low frequency in the data and reduce the nonlinearity of the problem. This is followed by a short-offset P-impedance optimization and a further step of full offset range Poisson’s ratio inversion. Provided that the seismogram contains wide reflection angles (>40°), we show that it is possible to invert for density and decompose a posteriori the relative contribution of P-wave velocity and density to the P-impedance. A broad range of synthetic tests is used to prove the potential of the methodology and highlights sensitivity issues specific to UHF seismic. An example application to real data is also presented. In the real case, trace normalization is applied to minimize the systematic error deriving from an inaccurate source wavelet estimation. The inverted model for the top 15 m of the subseabed agrees with the local lithological information and core-log data. Thus, we can obtain a detailed remote characterization of the shallow sediments using a multichannel sub-bottom profiler within a reasonable computing cost and with minimal pre-processing. This has the potential to reduce the need of extensive geotechnical coring campaigns.