This study focuses on testing cost-effective electrocatalysts for the oxygen evolution reaction to facilitate hydrogen generation from seawater electrolysis.
Carrying out electrolytic water splitting in an alkaline environment permits the usage of transition metal‐based electrode materials, compared to the significantly more expensive noble metal‐based materials required for electrolysis in an acidic environment. Of the two electrode processes that take place in a water electrolyser, the anodic oxygen evolution reaction (OER) is the bottleneck to the process, due to the sluggish kinetics of the reaction; thus, much research is being directed towards developing electrocatalysts to improve the efficiency of this process. Perovskites are a group of compounds that are emerging as promising OER electrocatalysts due to their low cost, good tunability and high catalytic activity. This review begins with the basic principles and fundamental limitations of the OER before exploring the trade‐offs between cost, activity, and durability that are often encountered in electrocatalyst design. Perovskites are then introduced as OER electrocatalysts, with a detailed discussion on structure, activity descriptors, catalyst design strategies, and synthesis methods. A critical review of recent advancements in perovskite materials as OER electrocatalysts is then presented at the end, including the latest developments in heteroatom doping and interface engineering.
8 April 2026 in Journal of the Electrochemical Society
This study presents a simple and scalable surface modification strategy to enhance the performance of nickel foam (NF) for alkaline water splitting. By employing a concentrated aqueous FeCl 3 etchant, we achieved anisotropic etching that preferentially attacks the (111) facet, creating a striped surface morphology. This structural modification significantly increases surface hydrophilicity and reduces gas bubble departure size by approximately 31%, facilitating superior mass transport and minimising active site blocking. Electrochemical testing demonstrates that NF etched for 30 min (NF30m) exhibits exceptional oxygen evolution reaction (OER) activity, achieving overpotentials of 262 mV and 485 mV at current densities of 10 and 1000 mA cm −2 , respectively, a substantial improvement over pristine NF, with good stability over 20 h at 500 mA cm −2 . Furthermore, a marked reduction in Tafel slope (from 66.7 to 36.0 mV dec −1 ) and increased charge transfer during Ni(II)/Ni(III) redox transitions suggest that the etching process promotes the formation of the highly active γ −NiOOH. These findings highlight surface engineering via controlled chemical etching as a potent route for developing high-efficiency, low-cost electrodes for industrial-scale hydrogen production.
Lithium-ion batteries have rapidly gained popularity due to their compact size, lightweight design, and favourable properties for portable electronics. However, due to flammable and toxic organic solvents in their electrolyte, they pose a considerable safety hazard; thus, solid electrolytes are being explored as potential alternatives. Various compounds are being investigated for suitability in this area, with ceramics, oxides, sulphides, nitrides, and polymers emerging as popular classes of interest [1]. Among the materials highly investigated is cellulose, a highly abundant material with intriguing properties, including stability, robustness and eco-friendliness. Cellulose nanofibrils (CNFs) have been successfully used as a supporting matrix for gel electrolytes [2] and a solid-state ion conductor, exhibiting ionic conductivity of 1.5 × 10−3 S cm−1 at room temperature [3].