Piezoelectric energy transducers offer great potential for converting the vibrations of pedestrian footsteps or cars moving on a bridge or road into electricity. However, existing piezoelectric energy-harvesting transducers are limited by their poor durability. In this paper, to enhance this durability, a piezoelectric energy transducer with a flexible piezoelectric sensor is fabricated in a tile protype with indirect touch points and a protective spring. The electrical output of the proposed transducer is examined as a function of pressure, frequency, displacement, and load resistance. The maximum output voltage and maximum output power obtained were 6.8 V and 4.5 mW, respectively, at a pressure of 70 kPa, a displacement of 2.5 mm, and a load resistance of 15 kΩ. The designed structure limits the risk of destroying the piezoelectric sensor during operation. The harvesting tile transducer can work properly even after 1000 cycles. Furthermore, to demonstrate its practical applications, the tile was placed on the floor of an overpass and a walking tunnel. Consequently, it was observed that the electrical energy harvested from the pedestrian footsteps could power an LED light fixture. The findings suggest that the proposed tile offers promise with respect to harvesting energy produced during transportation.
15 March 2016 in Active and Passive Electronic Components
We have demonstrated a method for using proper models of pentacene P-channel and fullerene N-channel thin-film transistors (TFTs) in order to design and simulate organic integrated circuits. Initially, the transistors were fabricated, and we measured their main physical and electrical parameters. Then, these organic TFTs (OTFTs) were modeled with support of an organic process design kit (OPDK) added in Cadence. The key specifications of the modeled elements were extracted from measured data, whereas the fitting ones were elected to replicate experimental curves. The simulating process proves that frequency responses of the TFTs cover all biosignal frequency ranges; hence, it is reasonable to deploy the elements to design integrated circuits used in biomedical applications. Complying with complementary rules, the organic circuits work properly, including logic gates, flip-flops, comparators, and analog-to-digital converters (ADCs) as well. The proposed successive-approximation-register (SAR) ADC consumes a power of 883.7 µW and achieves an ENOB of 5.05 bits, a SNR of 32.17 dB at a supply voltage of 10 V, and a sampling frequency of about 2 KHz.
Employment of high-k dielectric is one of the most important strategies to reduce operating voltage of an integrated circuit. This paper demonstrates experiments on organic FET and CMOS circuit where the dielectric layer was constructed of P(VDF-TrFE) and PS polymer dielectric. The dielectric constant of compound dielectric increased about three times in comparison with that of pristine PS. This contributes into lowering the operating voltage transistor circuit. The experimental results indicated that high-k dielectric of P(VDF-TrFE) and PS may be suitable for flexible low-power organic electronics.
Some organic double-edge triggered D flip-flops were designed with modeled organic thin-film transistors (OTFTs) and evaluated. The simulation results indicated that the circuit power consumption could be saved 20 times with the appropriate structure composing N-channel switches and TG-based MUX 2:1. In order to reduce consumption energy more deeply, the balance in the charge mobility of each transistor type needs to be set in complementary circuits. One of effective ways is varying the threshold voltage of either P-type or N-type transistors. In this work, the threshold voltage of the P-type elements have been tuned from -4.4 to 4.6 V to determine the optimal value for minimizing power dissipation of the circuit and maximizing its performance. At the optimal Vth, p of -0.9 V, the circuit parameters are rise time, fall time, delay clock-to-Q and power dissipation of 57 ns, 8 ns, 52 ns, and 835 nW, respectively, at the supply voltage of 10 V and the clock pulse frequency of 1 kHz.