This paper proposes a grouped, reactive power optimization control strategy to maximize the active power output of a doubly-fed induction generator (DFIG) based on a large wind farm (WF). Optimization problems are formulated based on established grouped loss models and the reactive power limits of the wind turbines (WTs). The WTs in the WF are grouped to relieve computational burden. The particle swarm optimization (PSO) algorithm is applied to optimize the distribution of reactive power among groups, and a proportional control strategy is used to distribute the reactive power requirements in each group. Furthermore, the proposed control strategy optimizes the reactive power distribution between the stator and the grid side converter (GSC) in each WT. The proposed control strategy greatly reduces the number of variables for optimization, and increases the calculation speed of the algorithm. Thus, the control strategy can not only increase the active power output of the WF but also enable the WF to track the reactive power dispatching instruction of the power grid. A simulation of the DFIG WF is given to verify the effectiveness of the proposed control strategy at different wind speeds and reactive power references.
The high voltage DC (HVDC) transmission technology of wind power system, with multi-phase permanent magnetic synchronous generator (PMSG) is proposed in this paper. Each set of three-phase winding of the multi-phase PMSG was connected to a diode rectifier. The output of the diode rectifier was connected by several parallel isolated DC–DC converters. Each DC–DC converter was connected to a sub-module (SM). All SMs and two inductors were connected in a series. The proposed wind power system has several advantages including, transformerless operation, low cost, low voltage stress, and high fault tolerance. The maximum power point tracking (MPPT) and energy balance of the DC–DC converters were achieved by controlling the duty cycles of the DC–DC converters. The HVDC transmission was achieved by the nearest level control (NLC) with voltage sorting. The simulation model with 18-phase PMSG was established. Experimental results were also studied based on RT-Lab.