19 December 2024 in Smart Materials and Structures
This paper presents a study on a multi-resonant tuneable vibration absorber for the control of flexural vibrations of thin structures in a low frequency band where the response is characterized by distinct lightly damped resonances of low order flexural modes. The absorber is formed by a tree of deflated composite beams made by a core structured fabric wrapped on a plastic skin. The beams have increasingly smaller length and are fixed in the middle on a mast that works as a base-post and vacuum-junction too. The fabric in each beam is made by a lattice of interlocked truss-like rigid particles. The uniform pressure exerted by the deflated skin forces the particles to jam such that the fabric moves from its natural fluid-like state to a solid state whose rigidity depends on the confining pressure exerted by the skin. Hence, each beam is characterized by a fundamental flapping vibration mode whose response resembles that of a classical mass-spring-damper vibration absorber and can be suitably tuned by adjusting the level of vacuum. The paper first analyses the working principles of single-beam and three-beams absorbers with respect to their vibration transmissibility and base impedance frequency response functions. Then, it presents the vibration control generated by the single-beam and the three-beams absorbers tuned to minimise the resonant responses of a single or three low order flexural modes of a thin plate. The paper shows that the operational frequency of each beam-absorber can be suitably adapted in a band of 8 Hz by varying the vacuum pressure in a 5–80 kPa range. Also, it shows that the single-beam or multi-beams absorbers reduce the resonant response of the target flexural modes by 10–20 dB.
12 October 2026 in Mechanical Systems and Signal Processing
27 July 2026 in SSRN Electronic Journal
Controlling flexural vibrations and sound transmission in thin-walled structures subjected to time-varying tonal excitations remains a major engineering challenge. While acoustic metamaterials have demonstrated significant potential for vibration attenuation, most tuneable designs rely on complex architectures that hinder practical implementation. This study proposes a lightweight composite panel integrating a simple honeycomb-core acoustic metamaterial capable of generating a continuously tuneable flexural vibration bandgap. The proposed concept consists of a tensioned wire routed in a continuous zigzag path through the honeycomb cells, with concentrated masses attached at the centre of each cell. Each wire–mass subsystem acts as a base-excited resonator whose natural frequency is controlled by the wire tension. The resulting periodic array of identical resonators enables continuous tuning of the resonance frequency and the associated flexural vibration stopband without modifying the structural layout. The design methodology is presented and validated through simulations and experimental testing of a prototype panel. The results demonstrate the formation of a flexural vibration stopband with a bandwidth of approximately 20 Hz and a maximum attenuation of about 20 dB. By varying the wire tension, the stopband can be shifted over a frequency range of approximately 400 Hz, allowing adaptive suppression of time-varying tonal disturbances. The proposed metamaterial combines structural simplicity, low mass, and robust tuneable dynamic behaviour, providing an effective strategy for adaptive vibration and noise control. Owing to its ease of implementation and broadband tunability, the concept is well suited for lightweight engineering structures operating under variable excitation conditions, including aerospace, automotive, marine, and industrial applications.