1 February 2009 in Ultrasonics
1 January 2013 in Proceedings of Meetings on Acoustics
Cross-talk in acoustical transducer arrays is an undesirable phenomenon which decreases seriously the performances of these arrays. Indeed, when one element of the array is driven, it generates parasitic displacement fields at the radiating surfaces of the neighboring elements, which changes the directivity of the antenna. To well understand this phenomenon a transducer array similar to those used in medical imaging and NDT applications was modelled by finite element method. The research work investigated systematically the effects of the cross-talk. Firstly, it inspected the acoustical and mechanical cross-talk throughout the propagating medium and the filling material. Secondly, it studied the influence of the matching layer on the acoustical performances of the transducer. It was shown that the filling material and the matching layer are the major factors contributing to this phenomenon. In order to cancel the cross-talk a correction method previously developed by the author has been used. This solution consisted in applying adapted electrical voltages on each neighboring element of the active one in the purpose to reduce the displacement field on their active surface. This method was tested numerically and the obtained results clearly demonstrated its ability to reduce the cross-talk.
1 May 2013 in The Journal of the Acoustical Society of America
1 May 2008 in The Journal of the Acoustical Society of America
The interactions of the fundamental Lamb modes with discontinuities in an isotropic structure will be presented and analyzed in a simple and a fast way. The key point is to decompose the symmetrical or asymmetrical notch into two elementary steps. The fundamental antisymmetrical and symmetrical Lamb modes contributions are separated by means of the simple arithmetic operations of addition and subtraction. The power reflection and transmission coefficients are then computed with the well‐known average power flow equation described in a previous work [NDT&E international, Vol. 41, p.1‐9 (2008)]. Using these coefficients, the symmetrical notch can be constructed from one elementary symmetrical step while the asymmetrical notch is constructed from the superposition of asymmetrical down‐ and up‐steps. Mode conversions phenomena are observed and analyzed for the asymmetrical steps and notches case. Finally, an experimental device is realized to test aluminum plates with different notch depths. Good agreement is found between experimental and numerical results.
1 March 2018 in The Journal of the Acoustical Society of America
The study of dispersive behavior of guided waves is of great interest in non-destructive testing and development of inspection systems. In this work, a semi-analytical numerical formulation for the computation of dispersion curves and mode shapes in plate-like structures is presented. The formulation is based on a discontinuous Galerkin Finite Element Method. The discretisation of the ordinary differential system in the through-thickness direction yields an eigenvalue problem. The resolution of the latter for a frequency range provides the dispersion curves. The study focuses on Lamb modes in functionally graded material plates with traction-free boundary conditions. The influence of the gradient variations is demonstrated. First, a multilayered approximation consisting of homogeneous laminate is used. Afterwards, the gradients of the parameters are added to the formulation. Numerical examples are presented and compared with those found in the literature. The results are free of spurious modes and show an excellent agreement for all cases, specially for continuously varying properties. The method is very efficient and numerically stable for small and large wave numbers. It was found that a high accuracy is obtained when high-order elements are used on a relatively coarse mesh.