10 February 2025 in IEEE Transactions on Geoscience and Remote Sensing
Signals emitted by ground-based sources frequently interfere with those received by spaceborne Synthetic Aperture Radar (SAR) systems, with periodic pulses from ground radars being the most common form of interference. This paper introduces a method to locate the source of these pulsed signals utilizing SAR echo data. Initially, the Time Difference of Arrival (TDOA) for each pulse transmitted by the interferer and received by the SAR satellite is estimated. A mapping relationship between the interferer coordinates (latitude and longitude) and the variations in TDOA is then established. Using this mapping, the localization of the interferer is finally performed via a two-dimensional search approach. The proposed method is highly versatile and applicable to systems consisting of one single SAR, constellations of SAR instruments, and configurations of multichannel single-instrument SAR systems. Regardless of the modulation form of the interfering signal, the method remains effective. The accuracy of the method is analyzed and the factors influencing the localization precision are investigated. Finally, using the Gaofen-3 spaceborne SAR, an experimental validation of the proposed TDOA-based localization method is performed. Results indicate that the positioning error of an interference source based on two consecutive satellite measurements is only 3.7 kilometers.
17 February 2026 in IEEE Transactions on Geoscience and Remote Sensing
Accurate localization of spaceborne Synthetic Aperture Radar (SAR) interference sources facilitates the search, identification, and characterization of interferers, while also providing prior information for enhancing interference suppression, making it a current research focus. For locating the most common ground-based co-frequency radar interferers in SAR satellite systems, several methods have been developed by exploiting the spatial variation of periodic pulse arrival times. However, high-power interference signals from ground radars tend to cause receiver saturation, leading to nonlinear distortion. This results in power loss in the fundamental component and generates homologous harmonics that compete with the fundamental, both severely degrading the fundamental jamming-to-noise ratio (JNR) and reducing the accuracy of existing fundamental time difference of arrival (TDOA)-based localization. To address this, this paper proposes a novel approach that turns the otherwise harmful harmonic components into beneficial resources to enhance localization performance. The fundamental and third-harmonic pulses are first extracted and separated from the SAR echoes. Theoretical and observed TDOA sequences are then computed for both components. Finally, accurate localization is achieved through a joint loss function. Simulations using the Geometric Dilution of Precision (GDOP) demonstrate that the proposed method improves localization accuracy under saturation compared to existing TDOA-based approaches. Experiments with GF-3B satellite dual-pass data confirm its effectiveness, reducing the localization error to 2.08 km.
24 March 2026 in IEEE Transactions on Geoscience and Remote Sensing
Ground-based radio frequency interference (RFI) signals, particularly periodic pulses, often cause severe disruption to spaceborne Synthetic Aperture Radar (SAR) systems, significantly degrading image quality. To address this issue, this paper proposes a novel method for locating ground radiation sources by exploiting the phase characteristics of SAR-received signals. Unlike conventional techniques, the proposed approach fully leverages the phase evolution induced by the relative motion between the satellite and the interferer. A joint observation model consistent with SAR imaging geometry is established, enabling long-duration coherent integration and high-precision phase modeling, thereby improving localization performance. To achieve unambiguous localization under phase cycle folding during coherent accumulation, a soft spatial masking strategy is introduced as a discrimination criterion, effectively suppressing false peaks and ensuring correct source positioning. The positioning accuracy of the method and its core influencing factors are systematically analyzed. Experimental results based on single-pass Gaofen-3 SAR data demonstrate a localization accuracy of 2.899 km—which is superior to the TDOA method using two passes. The method does not rely on multi-satellite collaboration, repeated observations, or external auxiliary information, offering a practical and feasible solution for ground RFI source localization using conventional SAR satellites.
1 January 2026 in IEEE Geoscience and Remote Sensing Letters