1 December 2007 in International Journal of Aeroacoustics
To obtain higher resolution acoustic source plots from microphone array measurements, deconvolution techniques are becoming increasingly popular. Deconvolution algorithms aim at identifying Point Spread Functions (PSF)in source plots, and may therefore fall short when actual beam patterns of measured noise sources are not similar to synthetically obtained PSF's. To overcome this, a new version of the classical deconvolution method CLEAN is proposed here: CLEAN-SC. By this new method, which is based on spatial source coherence, side lobes can be removed of actually measured beam patterns. Essentially, CLEAN-SC iteratively removes the part of the source plot which is spatially coherent with the peak source. A feature of CLEAN-SC is its ability to extract absolute sound power levels from the source plots. The merits of CLEAN-SC were demonstrated using array measurements of airframe noise on a scale model of the Airbus A340 in the 8 ×6 m2 closed test section of DNW-LLF.
1 February 2007 in Journal of Sound and Vibration
17 October 2010 in SAE International Journal of Advances and Current Practices in Mobility
An introduction is given of phased array beamforming techniques for locating acoustic sources. Starting from basic principles, the Conventional Beamforming technique is described. It is explained how this technique can be applied to wind tunnel measurements. Further, a number of advanced array processing techniques are discussed. One chapter is devoted to the array processing technique for the location of moving sources. This technique can be applied to rotating sources, for example on wind turbine blades, and to source location on aircraft flying over a microphone array.
21 July 2017 in International Journal of Aeroacoustics
RMRoberto Merino-Martinez
In this article, a high-resolution extension of CLEAN-SC is proposed: high-resolution-CLEAN-SC. Where CLEAN-SC uses peak sources in ‘dirty maps’ to define so-called source components, high-resolution-CLEAN-SC takes advantage of the fact that source components can likewise be derived from points at some distance from the peak, as long as these ‘source markers’ are on the main lobe of the point spread function. This is very useful when sources are closely spaced together, such that their point spread functions interfere. Then, alternative markers can be sought in which the relative influence by point spread functions of other source locations is minimised. For those markers, the source components agree better with the actual sources, which allows for better estimation of their locations and strengths. This article outlines the theory needed to understand this approach and discusses applications to 2D and 3D microphone array simulations with closely spaced sources. An experimental validation was performed with two closely spaced loudspeakers in an anechoic chamber.
1 July 2008 in The Journal of the Acoustical Society of America
In this paper, a beamforming correction for identifying dipole sources by means of phased microphone array measurements is presented and implemented numerically and experimentally. Conventional beamforming techniques, which are developed for monopole sources, can lead to significant errors when applied to reconstruct dipole sources. A previous correction technique to microphone signals is extended to account for both source location and source power for two-dimensional microphone arrays. The new dipole-beamforming algorithm is developed by modifying the basic source definition used for beamforming. This technique improves the previous signal correction method and yields a beamformer applicable to sources which are suspected to be dipole in nature. Numerical simulations are performed, which validate the capability of this beamformer to recover ideal dipole sources. The beamforming correction is applied to the identification of realistic aeolian-tone dipoles and shows an improvement of array performance on estimating dipole source powers.