1 November 2019 in Physics Letters B
1 November 2018 in Progress of Theoretical and Experimental Physics
1 August 2018 in IEEE Transactions on Nuclear Science
High-energy physics experiments must usually handle large transfer rates of experimental data. In particular, in recent years, the amount and speed of data handled in high-energy physics experiments have significantly increased, because signal waveforms from detectors are often recorded without reduction to maximize the flexibility of the offline analysis. To best exploit the available bandwidth of such data acquisition systems with waveform recording, we developed the real-time lossless waveform-compression firmware that is based on a delta-encoding technique. The firmware provides a compression ratio of 34% of the raw data produced, the fast analog-to-digital converter (FADC) boards of our application before transmission to a host computer. The resource consumption of a field-programmable gate array (FPGA) is not large, and a low-cost mid-range FPGA is sufficient to implement this proposed firmware. The firmware has been successfully implemented on an FADC board and was utilized to record signals from multiwire proportional chambers for the DeeMe experiment. In this paper, we present the theory related to the firmware design and its implementation on the FPGA.
1 May 2021 in Nuclear Instruments and Methods in Physics Research Section A: Accelerators, Spectrometers, Detectors and Associated Equipment
22 February 2023 in IEEE Transactions on Applied Superconductivity
A new muon beamline is under construction for the COMET Phase-I experiment at J-PARC. The experiment requires a negative muon beam with the world-highest intensity to search for muon-electron conversion processes. The muon beamline consists of a series of superconducting solenoid magnets to generate muons by 8 GeV pulsed proton beam from MR of J-PARC, to transport muons to the detectors. A radiation-tolerant superconducting solenoid, the Pion Capture Solenoid, is developed to generate a high magnetic field on a production target to trap pions and muons efficiently. A long curved solenoid, the Muon Transport Solenoid, with correction dipole coils is utilized not only to transport muons but also to select low-momentum muons against unnecessary particles. A large detector solenoid is planned to connect to the muon beamline with a gradually reduced solenoidal field tuned by additional small solenoids. This paper reports the status of the construction and commissioning of the superconducting magnet system.
5 August 2025 in Nuclear Instruments and Methods in Physics Research Section A: Accelerators, Spectrometers, Detectors and Associated Equipment