Jing Shi

Jing Shi

Auto-generated profile, based on publicly available information

Jing Shi

School of Materials Science and Technology, Ocean University of China, Qingdao 266100, China

Research Focus & Metrics

Academic Career Length

15Years (2012-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
21 December 2017 in Coatings
Verified
Journal Article
Open access
PDF file
BLBai-Song Li
Bai-Song Li
TWTie-Gang Wang
Tie-Gang Wang
Ji Cheng DingJi Cheng Ding
Ji Cheng Ding
YCYUJUN CAI
YUJUN CAI
JSJing Shi
Jing Shi
XZXitong Zhang
Xitong Zhang
The cutting properties of tools can be greatly improved by AlCrSiN coatings. The AlCrSiN coatings with nitrogen content in the range of 28.2–56.3 at.% were prepared by varying the N2/Ar flow ratio from 1/4 to 1/1. The influence of N2/Ar flow ratio on composition, microstructure, and mechanical properties, as well as the tribological properties, of the coatings was investigated. With increasing N content, the coating microstructure gradually evolved from single fcc-(Cr,Al)N (200) phase to the mixture of fcc-(Cr,Al)N and hcp-(Cr,Al)N phase, which corresponds to an increased crystallinity within the coatings. The coating presents the highest hardness and best wear resistance for an N2/Ar flow ratio of 1/1, but the film adhesive strength and inner stress decreased obviously with increasing N2/Ar flow ratio, which was attributed to the rapid reduction of particle kinetic energy induced by the obstruction of neutral nitride particles between target and substrates. The highest H3/E*2 value exhibited the lowest wear rate, at 0.81 × 10−14 m3/(N·m), indicating that it had the best resistance to plastic deformation. The main wear mechanisms of the as-deposited coatings were abrasive wear and adhesive wear. The increasing crystallinity of the interior coatings resulted in higher hardness and better tribological behavior with an increase in N2/Ar flow ratio.

25 July 2012
Verified
Conference Paper
Closed access
JWJunxiang Wang
Junxiang Wang
AJAnnan Jiang
Annan Jiang
JSJing Shi
Jing Shi
The fully implicit closest point projection method (CPPM) which avoids the phenomenon of the trial stress drifting from the yield surface is a new numerical integration algorithm. The CPPM has the high accuracy and stability of the numerical solution. The finite element solver is developed based on the elastic-plastic theory and the CPPM of the non-associative isotropic hardening Drucker-Prager constitutive model. The complex geotechnical engineering problem can be solved by the self-developed nonlinear finite element program, then the results show that the accuracy and practicality of the program.