Aiming at the problems of the low detection accuracy and difficult identification of the early weak fault signals of rolling bearings, this paper proposes a method for detecting the early weak fault signals of rolling bearings based on a double-coupled Duffing system and VMD. The influence rule of system initial value on the response characteristics of a double-coupled Duffing system is studied, and the basis for its determination is given. The frequency of the built-in power of the system is normalized, and a variance evaluation standard for the output value of the double-coupled Duffing system for weak fault signals detection is established. In order to solve the interference problem of fault monitoring signals, VMD is proposed to pre-process the fault monitoring signals. The weak fault signal detection method proposed in this paper is tested and verified by simulation signals and rolling bearing fault signals. The results show that the method proposed in this paper can detect the weak fault signal with the lowest signal-to-noise ratio reduced by 2.96 dB compared with the traditional Duffing detection system, and it can accurately detect the early weak fault signal of rolling bearings.
The high cutting temperature and poor thermal diffusion efficiency of nickel-based alloys during deep hole machining have become technical challenges in the hole machining field. In this paper, a finite element simulation model of Inconel-718 BTA ordinary drilling and vibration drilling processes was established by using Deform-3D finite element simulation software. The variations in the temperatures of the tool teeth and the workpiece at different positions of the nickel-based alloy under ordinary drilling and vibration drilling were investigated. Additionally, the wear pattern of each tool tooth under the two drilling methods was further analyzed by building an experimental platform for workpiece temperature detection, which reveals the wear and cooling mechanism of nickel-based alloy BTA deep hole drilling. The results show that the average temperatures of the external, intermediate, and central teeth were reduced by 18.1%, 21.1%, and 17.8%, respectively, during vibration drilling. In addition, the workpiece hole wall and hole bottom temperatures were reduced by 5.7% and 4.6%, respectively. To conclude, the experimental tests were consistent with the simulated temperature trends. BTA vibration drilling optimizes the heat exchange conditions between the cutter teeth and the workpiece during the drilling of nickel-based alloys, which effectively reduces the cutting temperature and, thus, improves the wear resistance of the cutter teeth.
In the research on the aerostatic spindle, for quantifying the influence of shaft shape errors on its rotation accuracy, the calculation models of unbalanced air film force (UAFF) and centrifugal inertia force (CIF) are established. Based on the typical shape of the shaft, three composite cylinder models are constructed. The data sources are selected from the cylindricity measurement results of the shaft and substituted into the model for calculation. The results show that, for the shaft in this paper, when the roundness deviation is ≤1.25 μm and the cylindricity deviation is ≤2 μm, the influence of shape errors on the rotation accuracy of the shaft is small enough. The harmonic analysis of the data source shows that the magnitude and stability of the UAFF on the shaft are determined by the actual shape of the shaft’s cylindrical surface, and cannot be inferred only by the value of shape errors.