19 December 2006 in IEEE Transactions on Plasma Science
A nanosecond repetitively pulsed plasma (NRPP) produced by electric pulses of 10 kV during 10 ns at a frequency of up to 30 kHz has been used to stabilize and improve the efficiency of a 25-kW lean turbulent premixed propane/air flame (ReD=30000) at atmospheric pressure. We show that, when placed in the recirculation zone of the flow, the plasma significantly increases the heat release and the combustion efficiency, thus allowing to stabilize the flame under lean conditions where it would not exist without plasma. Stabilization is obtained with a very low level of plasma power of about 75 W, or 0.3% of the maximum power of the flame. In addition, they find that at high flow rates, where the flame should normally blow out, the NRPP allows the existence of an intermittent V-shaped flame with significant heat release, and at even higher flow rates the existence of a small dome-shaped flame confined near the electrodes that can serve as a pilot flame to reignite the combustor. Optical emission spectroscopy measurements are presented to determine the temperature of the plasma-enhanced flame, the electron number density, and to identify the active species produced by the plasma, namely O, H, and OH
13 August 2015 in Philosophical Transactions of the Royal Society A: Mathematical, Physical and Engineering Sciences
This paper reports on an experimental study of the influence of a nanosecond repetitively pulsed spark discharge on the stability domain of a propane/air flame. This flame is produced in a lean premixed swirled combustor representative of an aeronautical combustion chamber. The lean extinction limits of the flame produced without and with plasma are determined and compared. It appears that only a low mean discharge power is necessary to increase the flame stability domain. Lastly, the effects of several parameters (pulse repetition frequency, global flowrate, electrode location) are studied.
12 August 2008 in IEEE Transactions on Plasma Science
Stabilization of lean premixed flames is a very promising way to reduce pollutant emissions in industrial burners such as gas turbines or aircraft engines. By applying an ultrashort repetitively pulsed discharge (6.8 kV, 15-ns duration, 30 kHz), stable flames can be obtained under the equivalence ratio limit without plasma. In this paper, this technique is used to stabilize a confined propane-air flame created by a swirled injector. The discharge is generated using a ring high-voltage electrode placed 5 mm downstream of the exit of the injector.
1 January 2011 in Proceedings of the Combustion Institute
1 January 2011 in Proceedings of the Combustion Institute