5 May 2021 in Physical Review E
In an experiment performed with a high-intensity and high-energy laser system, -particle production in proton-boron reaction by using a laser-driven proton beam was measured. particles were observed from the front and also from the rear side, even after a 2-mm-thick boron target. The data obtained in this experiment have been analyzed using a sequence of numerical simulations. The simulations clarify the mechanisms of -particle production and transport through the boron targets. -particle energies observed in the experiment and in the simulation reach 10–20 MeV through energy transfer from 20–30 MeV energy incident protons. Despite the lower cross sections for protons with energy above the sub-MeV resonances in the proton-boron reactions, – particles per steradian have been detected.
19 August 2021 in Nature Physics
8 December 2020 in Physical Review Research
The emission of high-energy photons is one of the major effects of relativistic laser-plasma interactions, which underpins a wide range of applications, from plasma diagnostics to radiography to nuclear physics and quantum electrodynamics studies. In the case of solid targets, such emission is usually dominated by Bremsstrahlung and radiative transitions of excited ions, yet one expects prolific synchrotron emission to kick in and eventually prevail at high enough laser intensities, such as those contemplated at various facilities under construction worldwide. In this paper, by means of advanced, self-consistent particle-in-cell numerical simulations, we present a detailed analysis of x-ray and -ray radiation under previously unexplored interaction conditions, involving ultrathin targets partially transparent to the laser light, yet accessible to multipetawatt laser systems during their early operation phase. We first examine the characteristics of synchrotron radiation from laser-driven plasmas of varying density and size. In particular, we show and explain the dependence of the angular distribution of the radiated photons on the transparency or opacity of the plasma. We then study the competition of the synchrotron and Bremsstrahlung emissions in copper foil targets irradiated with , 50-fs laser pulses. Synchrotron emission is observed to be maximized for target thicknesses of a few tens of nanometers, close to the relativistic transparency threshold, and to be superseded by Bremsstrahlung in targets a few microns thick. At their best efficiency, both mechanisms are found to radiate about 1% of the laser energy into photons with energies above 10 keV. Their energy and angular spectra are thoroughly analyzed in light of the ultrafast target expansion, the influence of which has been overlooked so far. Our results demonstrate that even using solid materials of relatively high atomic number and not-so-extreme laser pulse intensities, synchrotron radiation can be a strongly dominant and efficient source of energetic photons provided the targets are thin enough.
1 January 2023 in Physics of Plasmas
Strong electromagnetic pulses (EMPs) are generated from intense laser interactions with solid-density targets and can be guided by the target geometry, specifically through conductive connections to the ground. We present an experimental characterization by time- and spatial-resolved proton deflectometry of guided electromagnetic discharge pulses along wires including a coil, driven by 0.5 ps, 50 J, 1019 W/cm2 laser pulses. Proton-deflectometry allows us to time-resolve first the EMP due to the laser-driven target charging and then the return EMP from the ground through the conductive target stalk. Both EMPs have a typical duration of tens of ps and correspond to currents in the kA-range with electric-field amplitudes of multiple GV/m. The sub-mm coil in the target rod creates lensing effects on probing protons due to both magnetic- and electric-field contributions. This way, protons of the 10 MeV-energy range are focused over cm-scale distances. Experimental results are supported by analytical modeling and high-resolution numerical particle-in-cell simulations, unraveling the likely presence of a surface plasma, in which parameters define the discharge pulse dispersion in the non-linear propagation regime.
1 February 2021 in Physics of Plasmas
Generating thin and high density plasma slabs at a high repetition rate is a key issue for ultra-high intensity laser applications, such as plasma photonics, electron acceleration by few laser-cycle pulses, or collisionless shock acceleration of protons to high energies. In this paper, we present a scheme to generate such plasma slabs. It is based on the propagation and collision in a gas jet of two counter-propagating blast waves (BWs). Each BW is launched by a sudden and local heating induced by a nanosecond laser beam that propagates along the side of the jet. The resulting cylindrical BW expands perpendicular to the beam. The shock front, which is bent by the gas jet density gradient, pushes and compresses the plasma toward the jet center. By using two parallel ns laser beams, one on each side of the gas jet, this scheme enables us to tailor independently two opposite sides of the jet, while avoiding the damage risks associated with counterpropagating laser beams. A parametric study is performed using two and three dimensional hydrodynamic (single fluid), as well as kinetic (Fokker–Planck), simulations. This study shows that the BW bending combined with the collision in a stagnation regime increases the density by more than ten times and generates a very thin (down to few micrometers), near to over-critical plasma slab with a high density contrast (>100) and a lifetime of a few hundred picoseconds. Two dimensional particle-in-cell simulations are, then, used to study the influence of the plasma tailoring on proton acceleration by a high-intensity sub-picosecond laser pulse. It is shown that tailoring the plasma, not only at the entrance but also at the exit side of the picosecond-pulse, enhances the proton beam collimation and increases significantly the number of high energy protons, and their maximum energy.
1 November 2021 in Physics of Plasmas
It was proposed recently that laser-ion acceleration in gas jets may be significantly improved if each side of a gas jet target is tailored by an auxiliary nanosecond laser pulse [Marquès et al., Phys. Plasmas 28, 023103 (2021)]. In the present study, the proton acceleration by electrostatic shock in these one- or two-side tailored plasmas is investigated using particle-in-cell simulations. It is demonstrated that the formation of a thin plasma layer with a steep density profile and a maximum density of the order of the critical density strongly improves the proton acceleration in the forward direction with a maximum ion energy of tens of MeV with mildly relativistic laser pulses. Proton acceleration up to tens of MeV is predicted using realistic plasma density profiles obtained from tailored gas jet targets compared to a few MeV reported in other publications.