Grid synchronization stability is an important research topic for grid-forming converters. To prevent instability and undesired oscillations, the small-signal modeling and stability analysis must be performed, which requires the line impedance information. Nevertheless, the line impedance may be unknown in most cases. As a consequence, the designed control parameters may fail to satisfy the stability requirement. To fill in this research gap, this article presents a geometrical approach to evaluate and improve the small-signal synchronization stability of grid-forming converters. The proposed analytical approach maps the line impedance variation on a two-dimensional plane and identifies the stability boundary in a geometrical way. As a benefit, the controller of grid-forming converters can be explicitly designed to achieve the robust synchronization stability. Finally, the feasibility of the proposed technique is verified by simulation and hardware experimental results.
To facilitate the transformation from conventional power systems towards smart grids, the concept of microgrids has been widely applied in practice, serving as the medium to accommodate renewable generators. One crucial problem is the stability associated with microgrids. This paper proposes a converter-based power system stabilizer (CBPSS), acting as a supplementary control loop, to enhance the stability of the islanded microgrids. The goal of the proposed CBPSS is to stabilize the critical microgrid mode with the generation of a damping torque, and it is achieved with the identification of the forward loop from the CBPSS to the microgrid. Then, the parameters of the proposed CBPSS can be designed accordingly to compensate the phase lag of the identified forward loop. Besides, an eigenvalue-mobility-based method is presented to identify the optimal installation location of the CBPSS in microgrids. As a consequence, the maximum stabilizing effect can be realized with the least control effort. Finally, modal analysis and time-domain simulations as well as hardware experimental results confirm the effectiveness of the proposed method.