15 November 2010 in Journal of Experimental Biology
SUMMARY: Blind Mexican cave fish (Astyanax fasciatus) sense the presence of nearby objects by sensing changes in the water flow around their body. The information available to the fish using this hydrodynamic imaging ability depends on the properties of the flow field it generates while gliding and how this flow field is altered by the presence of objects. Here, we used particle image velocimetry to measure the flow fields around gliding blind cave fish as they moved through open water and when heading towards a wall. These measurements, combined with computational fluid dynamics models, were used to estimate the stimulus to the lateral line system of the fish. Our results showed that there was a high-pressure region around the nose of the fish, low-pressure regions corresponding to accelerated flow around the widest part of the body and a thick laminar boundary layer down the body. When approaching a wall head-on, the changes in the stimulus to the lateral line were confined to approximately the first 20% of the body. Assuming that the fish are sensitive to a certain relative change in lateral line stimuli, it was found that swimming at higher Reynolds numbers slightly decreased the distance at which the fish could detect a wall when approaching head-on, which is the opposite to what has previously been expected. However, when the effects of environmental noise are considered, swimming at higher speed may improve the signal to noise ratio of the stimulus to the lateral line.
9 February 2017 in Journal of Fluid Mechanics
Long-duration particle image velocimetry measurements in rough-bed open-channel flows (OCFs) reveal that the pre-multiplied spectra of the streamwise velocity have a bimodal distribution due to the presence of large- and very-large-scale motions (LSMs and VLSMs, respectively). The existence of VLSMs in boundary layers, pipes and closed channels has been acknowledged for some time, but strong supporting evidence for their presence in OCF has been lacking. The data reported in this paper fill this gap. Length scales of the LSMs and VLSMs in OCF exhibit different scaling properties; whereas the streamwise length of the LSM scales with the flow depth, the VLSM streamwise length does not scale purely with flow depth and may additionally depend on other scales such as the channel width, roughness height or viscous length. The transverse extent of the LSMs was found to increase with increasing elevation, but the VLSM transverse scale is anchored around two flow depths. The origin and nature of LSMs and VLSMs are still to be resolved, but differences in their scaling suggest that VLSMs in rough-bed OCFs form independently rather than as a spatial alignment of LSMs.
13 June 2019 in Journal of Fluid Mechanics
A theoretically based relationship for the Darcy–Weisbach friction factor $f$ for rough-bed open-channel flows is derived and discussed. The derivation procedure is based on the double averaging (in time and space) of the Navier–Stokes equation followed by repeated integration across the flow. The obtained relationship explicitly shows that the friction factor can be split into at least five additive components, due to: (i) viscous stress; (ii) turbulent stress; (iii) dispersive stress (which in turn can be subdivided into two parts, due to bed roughness and secondary currents); (iv) flow unsteadiness and non-uniformity; and (v) spatial heterogeneity of fluid stresses in a bed-parallel plane. These constitutive components account for the roughness geometry effect and highlight the significance of the turbulent and dispersive stresses in the near-bed region where their values are largest. To explore the potential of the proposed relationship, an extensive data set has been assembled by employing specially designed large-eddy simulations and laboratory experiments for a wide range of Reynolds numbers. Flows over self-affine rough boundaries, which are representative of natural and man-made surfaces, are considered. The data analysis focuses on the effects of roughness geometry (i.e. spectral slope in the bed elevation spectra), relative submergence of roughness elements and flow and roughness Reynolds numbers, all of which are found to be substantial. It is revealed that at sufficiently high Reynolds numbers the roughness-induced and secondary-currents-induced dispersive stresses may play significant roles in generating bed friction, complementing the dominant turbulent stress contribution.
28 January 2020 in Journal of Fluid Mechanics
It is widely acknowledged that streamwise ridges on the bed of open-channel flows generate secondary currents (SCs). A recent discovery of meandering long streamwise counter-rotating vortices in open-channel flows, known as very-large-scale motions (VLSMs), raises a question regarding the interrelations between VLSMs and SCs in flows over ridge-covered fully rough beds. To address it, we conducted long-duration experiments using stereoscopic particle image velocimetry, covering a range of ridge spacings (, two SC cells are formed between neighbouring ridges and VLSMs are entirely suppressed, suggesting that ridge-induced SCs prevent the formation of VLSMs by absorbing their energy or overpowering their formation. At the same time, velocity auto- and cross-spectra reveal a new feature that can be explained by low-amplitude meandering of the alternating low- and high-momentum flow regions associated with instantaneous manifestations of SCs. Two-point velocity correlations and smooth velocity field reconstructions using proper orthogonal decomposition further support the validity of this effect. Its origin is probably due to the instability related to the presence of inflection points in the spanwise distribution of the streamwise velocity within the SC cells. These results have implications for bed friction in open channels, where the friction factor may increase if depth-scale SCs are present, or decrease under conditions of sub-depth-scale SCs and suppressed VLSMs.
15 November 2010 in Journal of Experimental Biology
Blind Mexican cave fish (Astyanax fasciatus) are able to sense detailed information about objects by gliding alongside them and sensing changes in the flow field around their body using their lateral line sensory system. Hence the fish are able to build hydrodynamic images of their surroundings. This study measured the flow fields around blind cave fish using particle image velocimetry (PIV) as they swam parallel to a wall. Computational fluid dynamics models were also used to calculate the flow fields and the stimuli to the lateral line sensory system. Our results showed that characteristic changes in the form of the flow field occurred when the fish were within approximately 0.20 body lengths (BL) of a wall. The magnitude of these changes increased steadily as the distance between the fish and the wall was reduced. When the fish were within 0.02 BL of the wall there was a change in the form of the flow field owing to the merging of the boundary layers on the body of the fish and the wall. The stimuli to the lateral line appears to be sufficient for fish to detect walls when they are 0.10 BL away (the mean distance at which they normally swim from a wall), but insufficient for the fish to detect a wall when 0.25 BL away. This suggests that the nature of the flow fields surrounding the fish are such that hydrodynamic imaging can only be used by fish to detect surfaces at short range.
6 February 2020 in Journal of Fluid Mechanics
Stereoscopic particle image velocimetry (PIV) configured in two orthogonal planes was utilised to capture the flow structure at the instant of entrainment of spherical bed particles in open-channel flow. Experiments were conducted with lightweight target particles amongst a bed of coplanar fixed spheres with diameters of 16 mm. The protrusions of the target particles were set to give an average entrainment rate of . These protrusions were established from extensive initial experiments which utilised an automated mechanism to place spheres on the bed of the flume and record the time elapsed until they were entrained by the flow. The results showed that at lower flow depth to particle diameter ratios, bed particles are more stable and require larger protrusions to entrain at the same rate as at a larger depth. This effect is consistent with observations of reduced velocity variance and reduced drag force variance for lower flow submergences. The PIV measurements indicated that particle entrainment is associated with very large-scale motions which extend up to 50 flow depths in the streamwise direction. Contributions of smaller scale velocity and pressure spatial fluctuations are suppressed by a spatial averaging effect related to the particle size, and a temporal averaging effect related to the time taken to fully entrain a particle from its resting pocket. These observations are relevant to sediment transport modelling. However, further data are required to clarify the role of particle lift forces and particle shape in the entrainment process.