1 July 1994 in Journal of Applied Physics
Transient capacitance methods were used to analyze traps occurring in unintentionally doped n-type GaN grown by hydride vapor-phase epitaxy. Studies by deep-level transient spectroscopy (DLTS) and isothermal capacitance transient spectroscopy indicated the presence of three majority-carrier traps occurring at discrete energies below the conduction band with activation energies (eV) ΔE1=0.264±0.01, ΔE2=0.580±0.017, and ΔE3=0.665±0.017. The single-crystal films of GaN were grown on GaN formed by metal-organic chemical-vapor deposition and on sputter-deposited ZnO; a similar deep-level structure was found in both types of samples. Pulse-width modulation tests using DLTS to determine the capture rates of the traps showed that the capture process is nonexponential, perhaps due to the high trap concentration. The origins of the deep levels are discussed in light of secondary-ion-mass-spectroscopy analysis and group theory results in the literature.
8 November 1993 in Applied Physics Letters
A Schottky barrier on unintentionally doped n‐type GaN grown by hydride vapor phase epitaxy was obtained and characterized. Using vacuum evaporated gold as the Schottky barrier contact and aluminum for the ohmic contact, good quality diodes were obtained. The forward current ideality factor was n∼1.03 and the reverse bias leak current below 1×10−10 A at a reverse bias of −10 V. The barrier height φBn was determined to be 0.844 and 0.94 eV by current‐voltage and capacitance measurements, respectively.
1 October 1992 in Japanese Journal of Applied Physics
The relaxation process of the thermal strain in a GaN film due to the thermal expansion coefficient difference in the GaN(0001)/α-Al2O3(0001) heterostructure is studied by varying the film thickness of GaN in a wide range from 1 to 1200 µm. The lattice constant c has a large value of 5.191 Å at a film thickness less than a few microns, while it decreases to about 150 µm, and becomes constant above 150 µm, indicating that the strain is almost completely relaxed. The intrinsic lattice constants of wurtzite GaN free from the strain, a 0 and c 0, are determined to be 3.1892±0.0009 and 5.1850±0.0005 Å, respectively.
1 April 1993 in Japanese Journal of Applied Physics
Thermal strains and stresses due to the thermal expansion coefficient difference in GaN(0001)/α-Al2O3(0001) layered structures are studied by varying the film thickness of GaN from 0.6 to 1200 µm. The strain in GaN is greater in films of less than a few microns thickness. It is decreased in films of thickness from several to about a hundred microns, and is almost completely relaxed in those thicker than 100 µm. The stresses and strains in the heterostructure are calculated using a model in which relaxation due to cracking in the sapphire is considered. Three relaxation mechanisms of the thermal strain are found for different film thicknesses as follows: (a) only lattice deformation (20 µm).
30 November 1992 in Applied Physics Letters
In hydride vapor phase epitaxial (HVPE) growth of GaN, the sputtered ZnO layer has been found to be one of the best buffer layers because of the fact that physical properties of ZnO are nearly analogous with those of GaN. With a ZnO buffer layer, the reproducibility of growing GaN single crystal by HVPE has been greatly improved. The GaN films grown by this method show excellent crystalline, electrical, and optical properties. In particular, the Hall mobility of 1920 cm2 V−1 s−1 at 120 K is the highest value that has ever been reported by HVPE.
11 April 2011 in Applied Physics Letters
Green GaInN/GaN quantum well light-emitting diode (LED) wafers were grown on nanopatterned -plane sapphire substrate by metal-organic vapor phase epitaxy. Without roughening the chip surface, such LEDs show triple the light output over structures on planar sapphire. By quantitative analysis the enhancement was attributed to both, enhanced generation efficiency and extraction. The spectral interference and emission patterns reveal a 58% enhanced light extraction while photoluminescence reveals a doubling of the internal quantum efficiency. The latter was attributed to a 44% lower threading dislocation density as observed in transmission electron microscopy. The partial light output power measured from the sapphire side of the unencapsulated nanopatterned substrate LED die reaches 5.2 mW at 525 nm at 100 mA compared to 1.8 mW in the reference LED.