16 April 2026 in Periodica Polytechnica Mechanical Engineering
This study examines dry sliding friction between a hydrogenated amorphous carbon (a-C:H) diamond-like carbon (DLC) coating and a polypropylene homopolymer (PPH). The coating was deposited on a quenched and tempered 42CrMo4 steel specimen (39 ± 1 HRC). Friction tests were performed at three sliding speeds (v = 5, 50, and 500 mm/min) and three surface pressures (p = 2, 4, and 6 MPa). From the recorded friction-force curves, the static friction coefficient (μ0) was taken as the peak value at the onset of motion, while the dynamic friction coefficient (μdyn) was evaluated in the near steady-state (gross sliding) region. Both μ0 and μdyn increased with sliding speed: μ0 rose from about 0.24 to 0.33 and μdyn from about 0.22 to 0.32 in the investigated range. Surface pressure had a smaller effect: μ0 showed no clear pressure trend, whereas μdyn increased with pressure at a given speed. A two-factor analysis confirms that sliding speed is the dominant factor for both μ0 and μdyn, and it also indicates a weak non-linear speed dependence in this parameter range. Overall, the friction coefficient of the PPH–DLC pair remained approximately within 0.20–0.35 for v = 5–500 mm/min and p = 2–6 MPa.
16 April 2026 in Periodica Polytechnica Mechanical Engineering
The tribological behavior of metal–polymer friction pairs depends to a large extent on their surface roughness. In this study, we analyze the friction of C45 (1.0503) steel and polypropylene homopolymer (PPH) in terms of the surface roughness characteristics of the material pair subjected to friction. The results of the friction experiments described in the article showed that during the friction process, the investigated roughness parameters of the steel specimen (Ra – average surface roughness, Rz – roughness height or ten-point height, Rp – maximum peak height, Rv – maximum valley depth) remained essentially unchanged, while the same roughness parameters of the polymer surface significantly changed and adapted to the roughness characteristics of the steel. Ellipsometric measurements also confirmed the presence of a 20–30 nm thick polymer transition film on the steel surface, and there were parts of steel on the polymer surface as well. The obtained results indicate that in the case of metal–polymer friction pairs, the change in surface roughness is asymmetric (the surface roughness of the harder material shapes the softer surface). In contrast, material transfer is bidirectional. These must be taken into account in friction modeling and wear prediction.