The shallow depth underthrust earthquake of February 27, 2010 (Mw 8.8) ruptured the subduction plate interface in central Chile between 34°S and 38°S. We retrieve the spatial and temporal distribution of slip during this mega‐earthquake through a joint inversion of teleseismic records, InSAR and High Rate GPS (HRGPS) data. Additionally, our model is shown to agree with broadband surface waves. Rupture initiated at about 32 km depth and propagated bilaterally resulting in two main slip zones located SSW and NNE of the hypocenter. Nucleation did not take place within or at the edge of one of these main asperities, but in between. During the first 30s, slip propagated predominantly southwards. Later on, the rupture evolved more slowly and more symmetrically. Eventually, the northern asperity became predominant with maximum slip reaching about 20 m. Most of the seismic moment was released within 110s, a relatively short time, explained by the bilateral propagation. The overall average rupture velocity is 2.6 km/s but propagation occurred initially faster towards the south (3.2 km/s). Large slip did not reach the trench, a result consistent with the moderate size of the tsunami. Down‐dip, rupture stopped at about 50 km depth, in agreement with the lower limit of the locked zone inferred by Ruegg et al. (2009) from pre‐seismic GPS data.
The 2001 Kunlunshan earthquake was an extraordinary event that produced a 400-km-long surface rupture. Regional broadband recordings of this event provide an opportunity to accurately observe the speed at which a fault ruptures during an earthquake, which has important implications for seismic risk and for understanding earthquake physics. We determined that rupture propagated on the 400-km-long fault at an average speed of 3.7 to 3.9 km/s, which exceeds the shear velocity of the brittle part of the crust. Rupture started at sub–Rayleigh wave velocity and became supershear, probably approaching 5 km/s, after about 100 km of propagation.
We investigate the rupture process of the 25 April 2015 Gorkha earthquake (Mw = 7.9) using a kinematic joint inversion of teleseismic waves, strong motion data, high‐rate GPS, static GPS, and synthetic aperture radar (SAR) data. The rupture is found to be simple in terms of coseismic slip and even more in terms of rupture velocity, as both inversion results and a complementing back projection analysis show that the main slip patch broke unilaterally at a steady velocity of 3.1–3.3 km/s. This feature likely contributes to the moderate peak ground acceleration (0.2 g) observed in Kathmandu. The ~15 km deep rupture occurs along the base of the coupled portion of the Main Himalayan Thrust and does not break the area ranging from Kathmandu to the front. The limitation in length and width of the rupture cannot be identified in the preearthquake interseismic coupling distribution and is therefore discussed in light of the structural architecture of the megathrust.
We document a 1 week long slow slip event (SSE) with an equivalent moment magnitude of 6.0–6.3 which occurred in August 2010 below La Plata Island (Ecuador), south of the rupture area of the 1906 Mw = 8.8 megathrust earthquake. GPS data reveal that the SSE occurred at a depth of about 10 km, within the downdip part of a shallow (<15 km), isolated, locked patch along the subduction interface. The availability of both broadband seismometer and continuous geodetic station located at the La Plata Island, 10 km above the SSE, enables a careful analysis of the relationships between slow and rapid processes of stress release along the subduction interface. During the slow slip sequence, the seismic data show a sharp increase of the local seismicity, with more than 650 earthquakes detected, among which 50 have a moment magnitude between 1.8 and 4.1. However, the cumulative moment released through earthquakes accounts, at most, for 0.2% of the total moment release estimated from GPS displacements. Most of the largest earthquakes are located along or very close to the subduction interface with focal mechanism consistent with the relative plate motion. While the earthquake sizes show a classical distribution (Gutenberg‐Richter law with a b‐value close to 1), the space‐time occurrence presents a specific pattern. First, the largest earthquakes appear to occur randomly during the slow slip sequence, which further evidence that the seismicity is driven by the stress fluctuations related to aseismic slip. Moreover, the seismicity observed during the SSE consists in individual events and families of repeating earthquakes. These observations indicate that the stress increment induced by the episodic aseismic slip may lead both to sudden seismic moment release and to progressive rupture within small locked patches. This study offers an a posteriori interpretation of the seismogenesis in the Central Ecuador subduction zone, where intense seismic swarms have been regularly observed (1977, 1998, 2002, and 2005). These swarms have likely been triggered by large‐magnitude slow slip events.