Faramarz Fereshteh-Saniee

Faramarz Fereshteh-Saniee

Auto-generated profile, based on publicly available information

Faramarz Fereshteh-Saniee

Department of Mechanical Engineering, Faculty of Engineering, Bu-Ali Sina University, Hamedan, Iran

Research Focus & Metrics

Academic Career Length

23Years (2004-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
24 March 2015 in Journal of Materials Science
Verified
Journal Article
Closed access
PDF file
SSS. Sepahi-Boroujeni
S. Sepahi-Boroujeni
FFF. Fereshteh-Saniee
F. Fereshteh-Saniee


2 December 2023 in Materials Chemistry and Physics
Verified
Journal Article
Closed access
SKSaeid Karimi
Saeid Karimi
NFNaeimeh Fakhar
Naeimeh Fakhar
MFMehrdad Faraji
Mehrdad Faraji
FFFaramarz Fereshteh-Saniee
Faramarz Fereshteh-Saniee



7 March 2013 in Materials and Manufacturing Processes
Verified
Journal Article
Closed access
FFF. Fereshteh-Saniee
F. Fereshteh-Saniee
NFN. Fakhar
N. Fakhar
MKM. Karimi
M. Karimi
This article in concerned with studying the effect of die profile on the load and energy necessary for plane-strain forward extrusion. With this regard, the geometries of the second-order polynomial and exponential die profiles were optimized in order to minimize the required extrusion pressure calculated based on the slab method. These optimal extrusion dies and the relevant linear one were manufactured for three extrusion ratios. After performing the extrusion experiments, the corresponding finite-element simulations were carried out under the same test conditions. All the analytical, experimental, and numerical findings, which were in good agreement with each other, showed that for all the extrusion ratios, the optimized polynomial and exponential die profiles involved the minimum and maximum force and energy requirements for the process, respectively. Moreover, the influence of the die geometry was more apparent at lower extrusion ratios. When the experimental results were analyzed based on the Taguchi method, it was also found that the effect of the die profile on the maximum extrusion load was more than one third that of the extrusion ratio.