24 September 2024 in Optics Express
Stimulated Raman scattering (SRS) microscopy is a powerful label-free imaging technique that probes the vibrational response of chemicals with high specificity and sensitivity. High-power, quantum-enhanced SRS microscopes have been recently demonstrated and applied to polymers and biological samples. Quantum correlations, in the form of squeezed light, enable the microscopes to operate below the shot noise limit, enhancing their performance without increasing the illumination intensity. This addresses the signal-to-noise ratio (SNR) and speed constraints introduced by photodamage in shot noise-limited microscopes. Previous microscopes have either used single-beam squeezing, but with insufficient brightness to reach the optimal ratio of pump-to-Stokes intensity for maximum SNR, or have used twin-beam squeezing and suffered a 3 dB noise penalty. Here we report a quantum-enhanced Raman microscope that uses a bright squeezed single-beam, enabling operation at the optimal efficiency of the SRS process. The increase in brightness leads to multimode effects that degrade the squeezing level, which we partially overcome using spatial filtering. We apply our quantum-enhanced SRS microscope to biological samples and demonstrate quantum-enhanced multispectral imaging of living cells. The imaging speed of 100×100 pixels in 18 seconds allows the dynamics of cell organelles to be resolved. The SNR achieved is compatible with video-rate imaging, with the quantum correlations yielding a 20% improvement in imaging speed compared to shot noise-limited operation.
24 February 2022 in IEEE Access
We present the first application of balanced heterodyne detection, established in quantum optics, to Brillouin spectroscopy in biological tissues. The balanced detection cancels out a large part of the influence of the laser noise. The center wavelength is 1064nm and the frequency resolution is 30MHz. The frequency resolution and the accessible frequency range are only limited by the measurement time and the laser tuning range (30GHz), respectively. In this way, we were able to measure the Brillouin shift in acetone, water, gummy bears, glass, and even porcine eye lenses.