We study the Kashmir seismic gap using data from a network of local broadband stations spanning southeastern Kashmir Valley and Jammu. We detected and located several hundred earthquakes using continuous data recorded in our network. The earthquakes (ML 1.0–5.0) were relocated using probabilistic and relative location methods to obtain a subset of events with depth and spatial uncertainty ≤1.5 km. The earthquakes were found to cluster along two adjacent lines parallel to the strike of the Himalaya but at different depths. The SW cluster was found to be shallower (4–15 km) than the NE cluster (13–18 km). The events in the SW cluster shallowed toward NW from SE. We calculated the source mechanism of larger earthquakes (ML≥3.0) using global and local data sets. The source mechanism results show dominant thrust motion of the earthquakes in the NE cluster. Considering nodal planes dipping to the northeast as fault planes, we obtained the model of a steep frontal ramp close to the locked portion of the Main Himalayan Thrust. The model obtained for SW cluster of seismicity showed the presence of a lateral ramp dipping to the SE. Normal faulting was observed in the SW cluster. Our analysis shows two possible causes for the existence of these normal faults—the existing strike‐slip motion loading/unloading stresses on the lateral heterogeneities within the decollement or the transfer of potential energy by sediment yield of the river Chenab. The elevated flat situated northwest of the lateral ramp gives rise to very shallow microseismicity (4–7 km).
28 October 2023 in Journal of Geophysical Research: Solid Earth
The Kashmir “seismic gap” in NW Himalaya is marked by hinterland‐to‐foreland reduction in GPS‐geodetic arc‐normal convergence‐velocity and increase in horizontal strain‐rate, associated with occurrence of moderate‐to‐small earthquakes. We analyze continuous waveforms from Jammu and Kashmir seismological network (2015–2017) to detect and preliminarily locate 1064 events, followed by probabilistic non‐linear relocation of 360 well‐located local earthquakes, with magnitudes 0.6–4.7 and hypocentral depths 0–60 km. Hypocenters shallower than 20 km lie on or above the Main Himalayan Thrust (MHT), clustered beneath the Kishtwar Higher‐Himalaya. Hinterlandward dipping seismicity‐clusters coincide with a MHT mid‐crustal frontal ramp, marking a 50 km wide locked‐to‐creep transition. The frictionally‐locked up‐dip MHT segment is 100 km wide, capable of hosting a 8.4 earthquake, if ruptured completely. Clustered seismicity SW of the Kishtwar Window and to its east illuminate MHT lateral‐ramps, which may limit the rupture width and/or modulate the rupture propagation. Entirely seismogenic underthrust Indian‐crust poses additional hazard from large earthquakes within it.
The Himachal Pradesh Seismological NETwork (HiPSNET) was installed in 2019 across the northwestern Himachal Himalaya, comprising seven broadband seismograph systems. Teleseismic data with magnitude greater than 5.5 and in the distance range of 30-90° have been used to compute P-wave receiver functions (P-RFs). These P-RFs have been depth migrated to form a 2D common conversion point (CCP) stack profile across the strike of the Himalaya. The main features on the CCP profile are the positive impedance boundaries of the Moho and the mid-crust, and the negative impedance contrast boundary of the Main Himalayan Thrust (MHT). The Indian crust underthrust the Himachal Himalaya with a gentle dip of ~5-7° in the NE direction. The Moho depth increases from the foreland (SW) to the hinterland (NE). Beneath the Sub-Himalaya, the Moho is at a depth of ~45 km, and gradually deepens to ~60 km beneath the Lesser-Himalaya, and further to ~70 km beneath the Higher-to-Tethyan Himalaya. The MHT, associated with a low-velocity layer, has a flat-ramp geometry, and ranges in depth from ~10 km beneath the Sub-Himalaya to ~20 km beneath the Higher-Tethyan Himalaya. Precisely located small-to-moderate earthquakes, from previous studies, concentrate on or above the MHT frontal ramp structure. This possibly marks the locked-to-creep transition on the MHT, lying below the Higher-Himalaya.
We use teleseismic data from the Jammu and Kashmir Seismological NETwork, to perform P-wave receiver function spatial and common-conversion-point (CCP) stacks, and joint inversion with Rayleigh-wave group-velocity dispersion, to construct 3D Vs model of the Jammu and Kashmir (J&K) Himalaya. 2D-CCP and Vs profiles reveal increasing crustal thickness from the foreland-to-hinterland, and an under-thrust Indian crust beneath J&K. The Moho positive impedance-contrast boundary is at ∼45 km depth beneath Sub-Himalaya and deepens to ∼70 km beneath Higher-to-Tethyan Himalaya, with an overall gentle NE dip. The Main Himalayan Thurst (MHT) forms a low velocity layer (LVL) with negative impedance contrast, and has a flat–ramp geometry. The flat segment is beneath Sub-to-Lesser Himalaya at 6–10 km depth, and dips ∼4◦. The mid-crustal (frontal) ramp is beneath Kishtwar Higher-Himalaya and Zanskar Ranges at 10–16 km depth, and dips ∼13–17◦. Significant along-arc variation in crustal structure is observed between east (Kishtwar) and west (Kashmir Valley) segments. Beneath the Kishtwar Window we image a Lesser Himalayan duplex (LHD) bound between MHT sole-thrust and MCT roof-thrust. LHD horses dip at high angle to the bounding structures and are illuminated by moderate seismicity. Beneath the Pir-Panjal Ranges and Kashmir Valley, the underthrust crust is ∼10 km thicker, has higher crustal Vs , and a shallower flat MHT at ∼10 km depth. The westward shallowing of the MHT occurs through a lateral ramp beneath Kishtwar Himalaya. Aftershocks of the 2013 Kishtwar earthquake concentrate on the MHT frontal and lateral ramp intersection, and possibly marks the down-dip locked-to-creep transition.