During drying or desiccation of clay-type materials, some stresses appear. Usually they are compressional inside of the material and tensional close to the surface. If the tensional stresses exceed the material strength, the clay cracks. This article is devoted to the modeling and numerical simulation of this phenomenon. The proposed model consists of two parts. The mass transfer is described by a simple diffusion equation together with convective boundary conditions. In the mechanical part it is assumed that the clay is composed of small particles linked together by cohesive forces. These forces are described with the use of mesh models. Two models are proposed: elastic (mesh consists of springs) and viscoelastic one (mesh consists of Maxwell elements). Four types of clays were tested experimentally to obtain the model parameters. The tested materials were selected with respect to different mineralogical compositions that determine the water-bonding ability. Simulations of the convective drying of bricks made of these clays were performed. It was shown that the degree of cracking depends on the quartz content of the clay. The obtained results were compared with experimental ones and good agreement between simulations and experiment was obtained. Additionally, the inner forces caused by drying are analyzed and discussed in this work.
The mechanistic theory of drying is developed for the purpose of stress and strain analysis in wet clay-like materials subjected to convective drying. The aim of these studies is to show the difference in stress and strain patterns for cases when the material is considered to be elastic, viscoelastic, or elastic-plastic. Such an analysis is justified by the fact that many materials under drying, e.g., clay-like or woody materials, reveal different mechanical properties and safer, mostly inelastic deformations. In addition, inelastic models are able to describe some additional phenomena as, for example, stress reverse that often appears in dried materials. It is displayed through comparison of the experimental measurements with the numerical results obtained on the basis of inelastic constitutive equations applied to drying materials. These results show that drying models that include inelastic deformations are more realistic and present more natural stress and strain patterns than the purely elastic model. The analysis is presented on an example of kaolin-clay plate subjected to convective drying. The numerical results concerning inelastic deformations are visualized on plots and photographs taken from the samples tested experimentally.